Teknos Timantti 3 is a full matt water-borne acrylate dispersion primer for walls and ceilings indoors. This adhesion primer is mildew-resistant. Also suitable for application to galvanized sheet metal surfaces.
Teknos Timantti 3 is ideal for adhesion priming walls and ceilings indoors constructed from unpainted concrete, plaster, stopper, brick and building board surfaces. Teknos Timantti 3 can also be used as an adhesion primer for wall and ceiling surfaces previously painted with alkyd or dispersion paints. Also suitable for priming surfaces that are to be wallpapered or to which a stick-on wall covering (e.g. a non-woven wallpaper) is attached.
Teknos Timantti 3 can also be applied on galvanized sheet metal surfaces, such as air conditioning pipes. The product has been classified to Group M1 in Emission Classification of building materials.
- Scrub rating 2
- Resistant to mildew
In standard specifications, Teknos Timantti 3 is used as a primer under Teknos Timantti Clean for a hygiene friendly wall and ceiling paint system.
Clean the surface from dirt and dust. Wash previously painted, dirty surfaces with Teknos Rensa Super paint cleaner. Matt down hard or gloss surfaces by sanding and thereafter remove the dust. For smoothing of irregularities in the surface choose a suitable filler from the Teknos Silora series. The dried filler is sanded down and the dust removed.
Steel surfaces are primed with Teknos Ferrex Aqua anti-corrosive paint. Teknos Timantti 3 is a water-borne paint. Coatings, which are not waterproof, such as old
unpainted ceiling stopper or glue paint coats, must be removed before applying Teknos Timantti 3. Alternatively Teknos Futura 3 adhesion primer can be used as an insulation primer.
Before use stir the paint thoroughly. The paint can be diluted with water, if required, but dilution may impair the coverage of the paint. Apply by roller, spray or brush.
Recommended nozzle size for airless spray is 0.017 - 0.021''.
|Type:||Waterborne Acrylate Dispersion|
|Tintable:||Yes, to Teknos Interior Colours and RAL, BS Shades. Please note, bespoke tints are non refundable / exchangeable|
|VOC Content:||30.0g per Litre|
|Suitable Substrates:||For priming unpainted concrete, plaster, stopper, brick and building board surfaces. Can also be applied on galvanized sheet metal surfaces, such as air condition pipes.|
|Application Method:||Brush, Roller or Spray|
|Theoretical Coverage:||4 - 8 m2 per litre depending on the absorbency and coarseness of the substrate|
|Wet Film Thickness (WFT):|
|Dry Film Thickness (DFT):|
|Dust Free:||30 minutes at 23°C|
|Overcoatable:||1 hour at 23°C|
|Fit for Wallpapering:||24 hours at 23°C|
|Cleaner / Thinner:||Water. Wash the equipment immediately after use with detergent and warm water.|
|Packaging:||Available in 0.9, 2.7, 9 and 18 Litres|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.