This product is currently out of stock.
This Centrecoat DIY Thermoplastic Gas Torch is an ideal entry level tool for one off or small quantity application of thermoplastics to tarmac or concrete roads, playgrounds etc.
This entry level thermoplastic Gas Torch comes with 4 butane gas canisters. Each canister will be sufficient to apply approximately two to three 5m x 100mm wide rolls of thermoplastic tape. This is ideal for one off use by individuals who have small quantities of thermoplastic line marking or logos to apply. This product is also ideal for one off repair or even the application of overbanding tape.
This gas torch also has auto ignition via a simple push button piezo ignition switch. The flame is adjustable with a maximum operating temperature of 1300°C.
Important - Read operating instructions thoroughly prior to use. Only operate outside.
- Easy to Use
- Adjustable Flame
- Environmentally Friendly
- Lightweight & Portable
If however you have large quantities of thermoplastic to apply, we would suggest you use our Centrecoat Thermoplastic Gas Torch - see link.
The DIY Thermoplastic Gas torch is easy to use and should only be handled by a responsible adult. The gas cannisters are simply attached by a quarter of a turn below the handle of the torch.
Surface and Environment
The Thermoplastic Gas Torch can be used in playgrounds, car parks, on roads and paths to produce lines, logos, letters and numbers and can be used on almost any different surface.
- 4 x 227g Butane Cannisters
- 1 x Gas Torch
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.