Please note, this product is now discontinued. Contact our technical team for a suitable alternative.
Timberex® Aqua Plus PU is a water-based polymer wood coating for fast and easy industrial protection. Very rapid curing saves time and costs. Timberex® Aqua Plus stains and protects at the same time.
Timberex Aqua Plus PU is best suited for the coloured protection of wood internal flooring against stains and traffic.
Colours shown on this product are for guidance only as the finished result will depend on preparation, application volumes and wood species. Always test a small area first to ensure satisfactory results.
Punch down any nail heads, fill any small holes or imperfections with proprietary coloured timber filler (plastic wood) and leave to cure. The wood should not excessive gaps through which the product could seep and affect the bond of any adhesive layer or rooms below. Floors should be free from any barrier of penetration as the stain must be able to penetrate into the wood. If sanding is required, the final sanding should be done with a grade 150-180 paper. Clean the surface by vacuuming.
It is advisable to test a small area first to ensure that the desired result is achieved. Wear protective gloves and shoes during application. Shake and stir the product before and during use. Apply a thin even coat (15-18 g/m²) with a micro-fibre roller. After 30-45 minutes, use a patina disc for a light sanding to remove any potential grain raise and remove any dust from the surface using a cloth before applying a second coat as described above. A third coat is advisable for light colors. The surface will be dry after 45-60 minutes under normal conditions. The surface can under normal circumstance be taken into full use after 12-24 hours.
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.