£7.75 delivery on orders excluding certain products & postcodes *
Centrecoat Flexicoat utilises a tough acrylic binder system to give a durable hard wearing matt finish with superb opacity giving great depth of colour. For exterior application to brick, cement and plaster as a smooth premium masonry paint.
Apply using brush, roller, HVLP or airless spray. All surfaces to be coated must be clean, dry and free from any contaminants including dirt, algae, grease and loose or flaky paint. Loose or flaky paint can occur after painting has begun if painting over previous weak paint layers, to avoid this sand back any weak paint layers before painting commences.
If repairs are needed to be made use fillers of the same porosity and density as the main substrate, this will help achieve a uniform finish and reduce any chance of visible differences in colour or tone. Follow manufacturers instructions regarding application guides and drying times. If the wall/floor to be painted is uneven or highly porous, then a priming/mist coat may need to be applied. Apply a priming/mist coat by diluting with approximately 10% of clean water by weight.
It is important to note that highly porous surfaces that are not properly prepared can cause difficulties during application and may lead to an uneven colour finish.
If using more than one tin, check that the batch numbers of each tin match, if batch numbers vary ensure you intermix tins before use. Ensure to stir all tins thoroughly before use. Before full application, paint out a small test patch and allow to dry to ensure colour satisfaction. Apply only when temperatures are above 5ºC, failure to observe minimum temperature will result in poor film formation and poor adhesion.
Components: | Single Pack |
Type: | Water Based |
Finish: | Matt |
Stock Colours: | White |
Tintable: | Yes, to pastel shades. Please note, bespoke tints are non refundable / exchangeable |
VOC Content: | |
Volume Solids: | |
Suitable Substrates: | For exterior application to brick, cement and plaster. |
Application Method: | Brush , Roller, HVLP Spray & Airless spray |
Theoretical Coverage: | 10 m2 per litre per coat |
Wet Film Thickness (WFT): | |
Dry Film Thickness (DFT): | |
Induction Time: | - |
Pot Life: | - |
Surface Dry: | 2 hours at 20°C depending on airflow and humidity. |
Overcoatable: | 12 hours @ 20° depending on airflow and humidity. |
Fully Cured: | |
Cleaner / Thinner: | Water |
Shelf Life: | 12 months in unopened containers |
Packaging: | Available in 5 and 10 Litres |