Owatrol Prepdeck Stripper Cleaner

SKU
id4093
UN1719 (Class: 8, Pk Grp: II)
A professional, high grade paint stripper specially designed for the removing of old solid and semi transparent stains.
Available in 1, 2.5 and 10 Litres
From £33.90 £28.25
In stock
Only %1 left
Product Description

Owatrol Prepdeck Stripper / Cleaner is a professional, high-grade product for the removing of old solid and semi transparent stains, grade stamps and other finishes from wood.

Best Uses

Owatrol Prepdeck Stripper/Cleaner is a diluted product that makes a powerful cleaner for removing of old solid and semi-transparent stains, grade stamps, dirt and other surface contaminants and is a fast easy way to reduce mill glaze so that new wood will accept a penetrating finish.

  • Strips oils and old finishes from exterior woods including 100 % acrylics
  • Removes Mill Glaze on new wood.
  • Cleans weathered wood
  • Removes grade stamps
  • Improves penetration of finishes on new wood
  • Use neat or diluted
  • 3 products in one
  • For external wood only

It is important after application Prepdeck that Owatrol Net-trol Wood Cleaner & Colour Restorer is applied to neutralise the Prepdeck and ensure the correct PH level is achieved before the application of any other coating or penetrating finishes to prevent the failure of adhesion.

Application

Remove any loose and flaking finish. Brush off any physical surface contamination e.g. moss, general dirt etc. Shake or stir product well before and during use including diluted solutions.

Use Owatrol Prepdeck as is or dilute according to data sheet. After rinsing immediately neutralise the surface with Owatrol Net-Trol except where Owatrol Tropitech All-In-One is the chosen finish. See data sheet. Always work in the direction of the grain. Do Not use a wire brush. Work large areas in zones. Allow wood to dry thoroughly, 2-3 days, before refinishing.

Test Procedure
Apply Owatrol Prepdeck. Allow to work 10 minutes. Scrub the surface to see if finish or dirt is lifting. If lifting commence with the job, if not wait a further 5 minutes and test again, continue this process up to a maximum of 30 minutes.

Stripping and Cleaning
Work in areas that can be completed in 15-30 minutes. Apply Owatrol Prepdeck to the area to be stripped or cleaned and allow to work. After time established in the test, scrub the surface with a stiff nylon brush, if required flush with water at the same time or use a pressure washer at 725-1500 psi (50-103 bars) depending on the type of wood. Rinse thoroughly with fresh clean water, using the highest pressure from the water source available or use a pressure washer at 500-1000 psi (35-70 bars). Rinse adjacent areas at the same time.

NB: Any areas of stubborn stain/finish may be spot treated. Allow wood to become damp. Apply Owatrol Prepdeck and allow to work for a short period. Remove as directed above.

Removing Mill Glaze
Apply Owatrol Prepdeck to the area to be treated. Allow to work 20-30 minutes. Scrub the surface with a stiff nylon brush or use a pressure washer at 725-1500 psi (50-103 bars) depending on the type of wood. Rinse thoroughly with fresh clean water, using the highest pressure from the water source available or use a pressure washer at 500-1000 psi (35-70 bars). Rinse adjacent areas at the same time.

Removing Grade Stamps
Apply Owatrol Prepdeck undiluted and scrub until stamp is gone. Rinse thoroughly.

Consult our technical team for additional information and advice prior to using Owatrol Prepdeck on Oak and Chestnut.

After rinsing immediately neutralise surface with Owatrol Net-Trol except where Owatrol Tropitech All-In-One is the chosen finish.

Surface and Environment

Owatrol Prepdeck Stripper/Cleaner can be applied to all exterior wood including pressure treated wood, softwood and hard woods. All timber, pine and cedar surfaces can be treated using Prepdeck, for use on decks, docks, cladding and other woodwork surfaces.

Technical Details
  • A paint stripper that strips old finishes from exterior woods including 100% acrylics
  • Reduces mill glaze on new wood
  • Improves penetration of finishes on new wood
  • Removes grade stamps
  • Cleans weathered wood
  • Can be used neat or diluted.

Technical Info

Components: Single Pack
Type: Stripper / Cleaner
Finish: -
Stock Colours: Yellowish White / Amber
Tintable: No
VOC Content: N/A
Volume Solids: N/A
Suitable Substrates: For external wood
Application Method: Synthetic Brush, Synthetic Scrubbing Brush, Synthetic Roller, Garden Sprayer
Theoretical Coverage:
  • Undiluted: 3-4 m2 per litre
  • Diluted 1:1: Up to 8 m2 per litre
  • Diluted 1:4: Up to 16 m2 per litre
  • Diluted 1:10: Up to 40 m2 per litre
  • Actual coverage will vary depending on application method, type, texture, age and porosity of the wood
  • and the condition of the coating being stripped.
Cleaner / Thinner: Water
Shelf Life: 18 months in original unopened container
Packaging: Available in 1, 2.5 and 10 Litres
Product Video

Related Products