Coo-Var Shellac Prime-All is a heavy duty, shellac based coating designed to block out difficult stains and odours. Ideal for sealing tar, bitumen and creosoted surfaces and to prevent bleeding through in subsequently applied solvent based paints.
Coo-Var Shellac Prime-All exhibits heavy stain blocking making it an ideal coating for blocking out nicotine, pen, oils and water stains. Coo-Var Shellac Prime-All also has rapid drying properties. Suitable for application onto timber, wood, composites, plaster, cement and brickwork. Also suitable as a spot primer on exterior surfaces.
All surfaces should be clean, dry and free from oil, grease and loose flaking material. Stir Coo-Var Shellac Prime-All well before use. Apply via brush or roller. Apply a full coat with the minimum of brushwork. If a second coat is required, this can be applied after approximately 30 minutes. Avoid over brushing.
|VOC Content:||< 500.0g per Litre|
|Suitable Substrates:||For timber, wood composites, plaster, cement and brickwork. Seals tar, bitumen and creosoted areas. Can be used as a spot-primer on exterior surfaces.|
|Application Method:||Brush, Roller|
|Theoretical Coverage:||10.5 m2 per litre at 50 microns|
|Wet Film Thickness (WFT):||100 microns|
|Dry Film Thickness (DFT):||40 - 50 microns|
|Touch Dry:||10 minutes at 20°C|
|Overcoatable:||Minimum 30 minutes at 20°C|
|Fully Cured:||1 day at 20°C|
|Cleaner / Thinner:||Methylated Spirits|
|Shelf Life:||2 years unopened in original packaging|
|Packaging:||Available in 2.5 and 5 Litres|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.