Ronacrete Ronafix For Concrete Repairs

Ronacrete Ronafix for Concrete Repairs is a liquid additive for cement mortars which enhances physical and chemical properties, and allows mortars to be placed in thin sections.

Best Uses

Ronafix screeds are site batched screeding mortars and fine concretes. The mix design for each is Ronafix admixture, cement, medium grade sharp sand, aggregate as determined by the mix design, plus water. The components are measured by weight or by volume on site and mixed to form the screed.

Mortars containing Ronafix are used for a wide range of applications where thin high strength high performance mortars are required. Typical minimum application depth is 6mm.

• Will accept foot traffic after 24 hours
• Rapid drying - can receive floor coverings such as vinyl, tiles and carpet after 10 days at 50mm thick
• Excellent wear resistance
• Bonded screeds from 6mm, unbonded and floating from 35mm minimum thickness
• Improved compressive, flexural and tensile strength
• Compatible with underfloor heating systems
• Excellent resistance to passage of water and water vapour
• Suitable for screed pumps

They are used with a primer of Ronafix and cement, which achieves monolithic adhesion to correctly prepared concrete or screeds. Ronafix screeds are used to lay new screeds and toppings as thin as 6mm bonded or 35mm unbonded or floating. The cured mortar bonds securely to suitably prepared surfaces and is water-resistant.

There are 2 mix designs when using Ronafix as a concrete repair mortar. Ronafix Mix Design A is used for concrete repairs where there is no exposed steel reinforcement and Ronafix Mix Design D is used where any reinforcement is exposed.

Mixes

• Ronafix Mix A - Screed or screed repair from 6-50mm
• Ronafix Mix A1 - Screed or screeds repair from 25mm
• Ronafix Mix B - Granolithic Topping or repair from 15-25mm
• Ronafix Mix B1 - Granolithic Topping or repair from 25mm
• Ronafix Mix D - Use where steel reinforcement is exposed
• Ronafix Mix F - Floating screed from 35mm
• Ronafix Mix G - Fine concrete screed from 26mm

See the data sheet for the full mix requirements.

Application

Preparation
The substrate on which the Ronafix screeds are being placed must be structurally sound and stable and suitable to receive a high strength topping. Surfaces should ideally be vacuum shot blasted or similar to expose the aggregate and provide a mechanical key. All grease and oil must be removed. Dust, debris and loose material must be removed by vacuuming. Any defect or weakness in the substrate may result in failure of the topping placed in contact with it. The recommendations given in BS8204-3: 2004 Part 7 should be followed, to assess the suitability of the substrate and maximise the performance of the topping.

Note the minimum and maximum application depths for each mix design. Surfaces must be cut back to allow the minimum depth of mortar to be placed without feather edging.

Damping
The prepared surfaces must be thoroughly damped with clean water. Very porous surfaces may require soaking for up to 24 hours. All surplus water must be removed before the primer is applied.

Priming
Brush apply a coat of Ronafix / cement primer mixed 1:1 by volume to the damp surface immediately before applying the screed, at the rate of 3-4m2 approximately per litre of Ronafix. Mix the primer thoroughly and apply evenly over the surfaces ensuring total and uniform coverage, taking care to avoid ponding. Only prime an area of floor which can be covered by the mortar within the working time of the primer.

Note that the primer must not be allowed to dry. If it dries it must be thoroughly scratched and reapplied.

For full mixing, placing and curing details, see Product Data Sheet for full guidance.