NATO Approved Coatings

A durable 2 pack epoxy high build gloss finish for interior or exterior use, suitable for concrete floors.

A high build, 2 pack modfied epoxy barrier primer that is hard wearing against abrasion with excellent resistance to immersion in salt and fresh water...

For application to steel where blast cleaning may not be possible, excellent corrosion resistance.

A tough, hard wearing finish coat for application over properly primed surfaces.

A 2 pack, solvent-borne, self-curing, inorganic zinc silicate with outstanding resistance against weathering and abrasion.

Epoxy with glass flakes for blast-cleaned and protected steel.

Used as a temporary protective coating for steel surfaces prepared by abrasive blast cleaning.

A tough 2 pack epoxy finish coat For concrete that offers good abrasion and chemical resistance in corrosive environments.

A high solids, 2 pack epoxy brushing and spraying mastic, with micronised glass flake, aluminium and anti corrosives.

A highly durable, silicone alkyd high gloss finish designed for external marine superstructures.

Provides excellent long-term colour / gloss retention. Extended lifetime to first maintenance as part of a high end anti-corrosive system.

Formerly Amercoat 160 HF. A one component zinc rich epoxy primer.

A single pack, aluminium pigmented silicone resin coating that is heat resistant up to 540°C.

A 2 pack epoxy zinc phosphate primer suitable for the anti corrosive protection of carbon steel surfaces.

A water based, 2 pack epoxy gloss finish for hygienic interior use on walls, floors and ceilings.

A one component physically drying, fast drying vinyl coating that can be used as primer or mid coat in atmospheric and immersed environments.

A 2 pack silicone based tie-coat for fouling release systems that can be used on any new build or maintenance project.

2 pack polyamide-adduct epoxy paint. A protective coating to steel & metal surfaces in severely corrosive environments.

A high performance, low VOC, water borne 2 pack epoxy with a high gloss finish for structural steel and concrete floors.

An epoxy MIO surface tolerant epoxy protective system suitable for low temperature curing.

A quick drying two component epoxy primer for immersed or exposed conditions within a system.

A 2 pack zinc phosphate epoxy wet blast primer for application to surfaces which have been prepared by wet abrasive blasting.

A two component, chemically resistant, high solids, high build epoxy phenolic tank and pipe lining.

A 2 part, abrasion resistant pure epoxy. Provides excellent long term anti-corrosive protection offshore or below water.

For application to steel tank internals.

This product is now discontinued. See PPG Vikote 63 as a potential alternative.