Jotun Vinylguard Silver Grey 88 is recommended as a marine coating for topside, deck and superstructure carbon steel substrates. Also suitable as a tie coat for anti-fouling systems. Jotun Vinylguard Silver Grey 88 is suitable for continuous temperatures of 60°C and 40°C if immersed in sea water.
Prepare carbon steel to SA 2 1/2 and ensure all surfaces are clean, dry and free from any contamination. For previously coated substrates ensure a compatible coating is used and that it is clean and dry as well as undamaged. Apply using an air or airless spray. Use a brush to apply product for stripe coating and small areas. Check to ensure the DFT is allowed for. Use a roller to apply on small areas. Roller is not recommended for first primer coat. Care must be taken to achieve the specified dry film thickness.
When applicable, products primarily meant for use as primers or anti-foulings may have slight colour variations from batch to batch. Such products may fade and chalk when exposed to sunlight and weathering.
When used as part of an approved scheme, this material has the following certification:
|Stock Colours:||Aluminium, Aluminium Red Tone|
|VOC Content:||551g per Litre|
|Suitable Substrates:||Properly prepared carbon steel substrates|
|Application Method:||Air Sprayer, Airless Sprayer, Brush or Roller|
|Theoretical Coverage:||10.9 - 3.8m2 per litre depending on system|
|Dry Film Thickness (DFT):||35 - 100 microns per coat.|
|Touch Dry:||20 minutes at 10°C.|
|Recoatable:||3 hours minimum|
|Cleaner / Thinner:||Jotun Thinner No.7|
|Shelf Life:||48 months at 23°C|
|Packaging:||5 and 20 Litre tins|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.