Sherwin Williams M535 - Formerly Leighs Resistex M535

Sherwin Williams M535 - Formerly Leighs Resistex M535

SKU id9223
A single pack, pitch free, vinyl copolymer resin based underwater coating for blast cleaned steel.
Available in 5 Litres
£59.87 (£71.84 Inc VAT)
*These colours are for guidance only. Variations between output devices can misrepresent the appearance of an actual colour. Also, we strongly advise that you order your complete paint requirements simultaneously to ensure a uniform batch colour.
£59.87 (£71.84 Inc VAT)

Product Description

Sherwin Williams M535 - Formerly Leighs Resistex M535 is a single pack, pitch free, vinyl copolymer resin based underwater coating for blast cleaned steel.

Best Uses

Sherwin M535 provides anticorrosive protection when applied onto blast cleaned steel. Formulated to be used in situations where coal tar pitch products are excluded on health and safety grounds, or where bleed through of pitch into topcoats is not acceptable.

Application

Recommended application via airless spray, roller or brush for small areas and touch up only. Recommended thinner cleanser no9. Recommended Primers: Macropoxy L574 Blast Primer, Macropoxy L425, Macropoxy C425V2. Blast clean to Sa2½ BS EN ISO 8501-1:2007. Average surface profile in the range 50-75 microns. Manually prepared surfaces should be prepared to a minimum standard of St3 BS EN ISO 8501-1:2007 at the time of coating. Ensure surfaces to be coated are clean, dry and free from all surface contamination. May also be applied over a wide range of pre-fabrication primers, including inorganic zinc silicate and epoxy types. Indefinitely overcoatable by itself or by a wide range of antifouling compositions. Where this material is used as a touch-up primer on ships bottom systems, care must be exercised to keep overlap of the primer onto existing coatings to a minimum. The nature of solvents in this material may cause some shrinking and crazing of certain antifouling coatings if excessive overlap occurs. This effect is purely cosmetic and will not affect the corrosion resistance of the overall system, however careful supervision and application will reduce the effect to a minimum.

Recommended Products To Use


Sherwin Williams Macropoxy L425 - Formerly Leighs Epigrip

Sherwin Williams Macropoxy L425 - Formerly Leighs Epigrip

A 2 pack epoxy zinc phosphate primer suitable for the anti corrosive protection of carbon steel surfaces.

From £77.07 (£92.48 Inc VAT)
Sherwin Williams Macropoxy L574 - Formerly Leighs Metagard

Sherwin Williams Macropoxy L574 - Formerly Leighs Metagard

Used as a temporary protective coating for steel surfaces prepared by abrasive blast cleaning

From £57.03 (£68.44 Inc VAT)
Sherwin Williams Macropoxy C425V2 - Formerly Leighs Epigrip

Sherwin Williams Macropoxy C425V2 - Formerly Leighs Epigrip

A high build, 2 pack epoxy, zinc phosphate primer / buildcoat for the anti corrosive protection of steel.

From £80.08 (£96.10 Inc VAT)
Sherwin Williams Cleanser Thinner No 9

Sherwin Williams Cleanser Thinner No 9

A solvent based, specially formulated product to use alongside compatible Sherwin Williams products.

From £26.14 (£31.37 Inc VAT)