LRS RapidRoof Ponding Filler

This product has been discontinued and replaced with LRS RapidRoof Multi-Purpose Filler.

LRS RapidRoof Ponding Filler is a rapid curing, extremely hard wearing solution for eliminating ponded areas on roofs within an LRS RapidRoof system.

Best Uses

LRS RapidRoof Ponding Filler is an ideal solution for application on to flat roof / balcony surfaces allowing a completely level surface to be achieved prior to application of a surface coating. Cures in approximately 30 mins to allow for fast work.

• High Strength
• Very good chemical resistance
• Excellent adhesion
• Fast curing, even at low temperatures
• Impact and abrasion resistant
• Frost resistant and impervious to water
• Excellent mechanical properties

LRS RapidRoof Ponding Filler provides excellent resistance to dilute acids and alkalis, oil, petrol, and diesel.

Application

Remove all laitance, grease, oil, dust and other contaminants to provide a sound, clean substrate.

PRIMING:
The prepared concrete surface should be primed by the application of LRS RapidRoof Primer. The mixed LRS RapidRoof Primer should be applied by brush or roller at a nominal rate of 1kg per 3-4m², depending upon surface profile. Allow the primer to cure for a minimum of 60 minutes.

MIXING:
LRS RapidRoof Ponding Filler is supplied as a two component product consisting of the BASE component, and the FILLER/CATALYST component. The contents of the BASE and FILLER/CATALYST component should be thoroughly mixed together for 1-2 minutes, until a uniform consistency is achieved. Mix using a low speed drill stirrer.

APPLICATION:
LRS RapidRoof Ponding Filler should be poured onto the primed floor and trowel finished. The material should not be feather edged.

CURING:
Allow a minimum cure time of 1 hour @ 20°C prior to foot trafficking and 2 hours @ 20ºprior to full trafficking. The cured product requires priming with LRS RapidRoof Primer prior to the application of any other LRS system.