Axalta Bondon 115

Axalta Bondon 115 is a two-pack epoxy, high solids, surface tolerant aluminium primer.

Best Uses

Axalta Bondon 115 is suitable for use as a rust inhibiting primer on hand prepared steel, or as a high build patch repair primer under most generic coating types.

• Excellent anti-corrosive protection
• Excellent ‘wetting’ properties for application to a manually prepared steel surface
• Good chemical and solvent resistance
• Use to upgrade a conventional system to high performance epoxy/polyurethane system
• Can overlap onto aged, sound chlorinated rubber, vinyl or alkyd products

Application

All surfaces to be coated should be dry and cleaned as necessary to remove all oil, grease, salts, weld flux or other contamination. Where necessary, remove weld spatter and grind smooth all sharp edges and weld seams. Blast clean to Sa2½ (ISO 8501-1:2007), surface profile 50-75 microns. Where blast cleaning is impractical the surface should be prepared to St2 (ISO 8501-1:2007) taking care to avoid ‘polishing’ the surface.

Can be used as a brush or spray applied primer when water abrasive blast cleaning. Allow to dry and lightly wire brush if powdery deposits form.

Mix only in the proportions stated, mixing each component individually then together using a mechanical agitator. Agitate periodically during use to ensure product remains homogeneous.

Airless Spray: Output fluid pressure at tip 2000-3000 psi, Tip Size: 13-21 thou (0.33-0.53mm). Brush application is preferred over manually prepared bare steel surfaces to assist surface penetration. If applying by roller over blast cleaned steel, there is a tendency to over spread the coating resulting in low film builds. If the film build is too low a second coat should be applied to achieve the required film build.