Axalta ViterClad M50 Cladding Coating

Axalta ViterClad M50 is a two pack recoatable polyurethane finish with a metallic finish, specially formulated for the maintenance and repainting of architectural cladding.

Best Uses

Axalta ViterClad M50 is recommended for the maintenance of TATA Steel Colorcoat HP200 and HPS200 cladding.

• Expected system lifetime up to 15 years (depending on exposed environment and shade)
• Tough, durable finish combining abrasion resistance with outstanding colour and sheen retention
• Good cleaning properties for ease of building maintenance
• Cures at sub-zero temperatures and has good climatic tolerance
• Tolerant of slight surface moisture during application

Axalta ViterClad M50 is suitable for PVF2, silicone polyester & polyester cladding when applied over Axalta ViterClad Bonding Coat. Suitable for urban, marine and industrial environments.

Application

This product is a finish coat which should be applied over Axalta ViterClad Bonding Coat or suitably prepared, sound Plastisol for recolour work. For aged/degraded Plastisol, condition diagnosis and correct surface preparation are critical to performance. Please consult our technical team for individual project specifications.

Completely new and unweathered HP200 Plastisol must be wiped with white spirit (Axalta 1050 Thinner) and allowed to dry prior to applying ViterClad 50. New HPS200 Plastisol must be wiped with xylene (Axalta 1006 Thinner) and allowed to dry prior to applying ViterClad 50.

For PVF2, Silicone Polyester and other cladding types, contact our technical team. Surfaces should be clean, dry and free from all grease, oil and general contamination.

Mix only in the proportions stated, mixing each component individually then together using a mechanical agitator. Agitate periodically during use to ensure product remains homogeneous.

Airless Spray is recommended for best finish. Output fluid pressure at tip 2000-2500 psi, Tip Size: 11-13 thou (0.33-0.43mm). Up to 5% Axalta 1737 Thinner may be added for application under cool or hot conditions, but thinning should be avoided if possible.

Conventional spray is possible but not recommended. Also, brush application is not recommended due to metallic finish. For roller application, use only good quality short hair roller types of suitable width to accommodate the cladding profile and configuration – always work from a wet edge. Up to 10% thinner may be required. Use Axalta 1048 Thinner when applying by roller in warm conditions.

We strongly recommend that a feasibility test area is applied to confirm acceptable aesthetics are achievable.

IMPORTANT NOTICE: From 24th August 2023, adequate training is required before industrial or professional use of this product. Training can be accessed at: https://www.safeusediisocyanates.eu