Axalta ViterFloor 300

Axalta ViterFloor 300 (Formerly Spencer Coatings) is a solvent free, two pack high build coating for concrete floors.

Best Uses

Axalta ViterFloor 300 is a solvent free, two pack epoxy high build floor coating formulated for new and old concrete floors subject to heavy mechanical wear and/or chemical attack. ViterFloor 300 is ideal for application in areas such as the food processing, brewing, pharmaceutical and heavy engineering industries.

Benefits from a high gloss, easily cleanable finish – coating previously held certification for ‘Ease of Decontamination’ in the nuclear industry. ViterFloor 300 is resistant to water, oils, weak solutions of non-oxidising acids, alkali and salt solutions, and temporary splashes of oxidising acids and bleaches.

Application

All surfaces must be clean, dry, and free from grease, oil, dust and other contamination. Apply over Axalta ViterFloor 400 primer/sealer – consult Product Data Sheet for details.

Must be mixed thoroughly by using a mechanical mixer (with side scraper) before use. Add hardener in the correct proportions and mix thoroughly for a minimum of 2 minutes. Mix the material just before use, and consider the area to be coated and pot life of the material when deciding how many units are required.

Note: do not scrape or pour out remaining residues of mixed material from the bottom and sides of the container onto the floor, as this material may be incompletely mixed and cause ‘soft spots’ in the applied floor coating. It is recommended that all material is stored at a temperature of approximately 20ºC for at least 24 hours prior to use, to aid mixing and application.