Available in gun and pouring grades. See Fosroc Thioflex 600 Gun Grade.
Fosroc Thioflex 600 is particularly recommended for use in high-rise buildings and other applications where access for subsequent maintenance will be difficult and the risk of early movement failure must be minimised. It is also suitable for sealing joints in brickwork, retaining walls, basements and subways. Recommended for initial sealing of expansion joints and stress relief joints in floors and sealing other horizontal surfaces.
Fosroc Thioflex 600 Pouring Grade is formulated for use within joints in horizontal surfaces is supplied in 5 litre packs with the base and curing agent in separate tins.
Thioflex 600 may be applied to joints between 5 and 50 mm wide. Joints which are expected to experience cyclic movements should be designed to an optimum width : depth ratio of 2: 1, subject to the overriding recommended minimum sealant depths set out below:
The use of a surface primer is always required on porous surfaces. On non-porous surfaces a primer is not normally required except where glass or glazed surfaces are to be permanently immersed in water.
|Suitable Substrates:||Metals, Glass, Non porous substrates, prous surfaces, trafficked joints|
|Application Method:||Pouring Grade|
|Theoretical Coverage:||See product data sheet|
|Wet Film Thickness (WFT):||See product data sheet|
|Dry Film Thickness (DFT):||See product data sheet|
|Pot Life:||2 hours at 25°C|
|Setting Time:||36 hours at 15°C|
|Fully Cured:||2 weeks at 15°C|
|Cleaner / Thinner:||Clean equipment immediately after use with Fosroc Equipment Cleaner.|
|Shelf Life:||12 months in original containers when kept in dry conditions between 5°C and 27°C.|
|Packaging:||Available in 5 Litres|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.