£7.75 delivery on orders excluding certain products & postcodes *
Interplus 634 is specifically designed to remove tightly adhering coating residues from metallic substrates prior to repainting with approved maintenance coatings. Coating residues include conventional epoxies, polyurethanes, alkyds, acrylics and water borne coatings.
Interplus 634 can be used where traditional surface preparation techniques, such as abrasive blasting, ultra high pressure hydroblasting or power tool methods are ruled out for operational, health & safety or environmental reasons.
Prior to application of Interplus 634, any loose rust or loose coating residue should be removed to aid penetration of the product. Surfaces not to be treated should be masked and protected with polyethylene. A strong ground sheet should be used to contain coating residue, product and rinse water.
Test Patch
It is strongly recommended that a small test patch should always be carried out on a representative area in order to ascertain the optimum application thickness and activation time required to successfully remove the coating residue. Activation times are very much dependent upon the in situ coating type and condition, however, a typical working time is within 6 to 16 hours. The resultant rinse washings collected during removal should be analysed by an independent laboratory to ensure disposal in accordance with local environmental legislation.
Application Conditions
Optimal working temperature range is 5 - 35°C (41 - 95°F), however, it can be used at temperatures as low as 0°C (32°F) and a maximum of 60°C (140°F). For best results, it is advised to suitably cover the application area to reduce the effect of wind, rain and intense sunlight.
The following primers are approved for application direct to Interplus 634 treated surfaces:
Components: | Single Pack |
Type: | Water Based |
Finish: | - |
Stock Colours: | Pale Blue |
Tintable: | No |
VOC Content: | 392 g/L |
Volume Solids: | - |
Suitable Substrates: | For metallic substrates. |
Application Method: | Airless Spray, Roller, Brush |
Theoretical Coverage: | 2 m2 per litre (80 sq.ft/US gallon) is typically achieved when applied at a thickness of 500μm (20 mils) |
Wet Film Thickness (WFT): | 500 microns/coat |
Dry Film Thickness (DFT): | |
Induction Time: | - |
Pot Life: | - |
Surface Dry: | |
Overcoatable: | |
Fully Cured: | |
Cleaner / Thinner: | Clean with water |
Shelf Life: | 12 months minimum at 25°C (77°F). Subject to re-inspection thereafter. Store in dry, shaded conditions away from sources of heat and ignition. Protect from freezing at all times during storage. |
Packaging: | Available in 20 Litres |