PPG SigmaTherm 230 Phenolic Epoxy
PPG SigmaTherm 230 is a two component high build heat resistant phenolic epoxy coating designed for use under insulation systems to provide heat protection of up to 230°C.
Best Uses
SigmaTherm 230 is a high performance, heat resistant product that provides protection to a variety of metal substrates. PPG SigmaTherm 230 is ideally suited for application to pipes, radiators and low heat engines to aid the protection of the surface and surrounding area.
Application
Blast clean steel to ISO-Sa2.5 with a blasting profile of 40 - 70 microns. The substrate must be perfectly dry before and during application. Degrease stainless steel with solvents and sweep blast. The temperature of the mixed base and hardener should be above 15°C otherwise extra thinner may be required. Adding to much thinner results in reduced sag resistance. Allow sufficient induction time as per data sheet.
Surface and Environment
SigmaTherm 230 is a high performance product that provides surfaces with a high glossy finish to aid protection and offer a level of decoration with an aluminium effect. SigmaTherm 230 should ideally be used internally to offer heat resistance to appliances of up to 230°C.
| Components: | Two Components |
| Type: | Epoxy Phenol Novolac Coating |
| Stock Colours: | Pink or Grey |
| Tintable: | No |
| Suitable Substrates: | Metal |
| Cleaner / Thinner: | PPG Thinner 91-92. Clean with Thinner 90-53 |
| Shelf Life: | At least 12 months when stored cool and dry |
| Packaging: | Available in 20 Litres |
| VOC Content: | 329.0 g/l |
| Application Method: | Air Spray, Airless Spray, Brush, Roller |
| Theoretical Coverage: | 4.5m2 per litre for 150 microns |
| Finish: | Eggshell |
| Touch Dry: | 3 hours at 20°C |
| Fully Cured: | 3 days at 20°C |
| Volume Solids: | 68 +/- 2% |
| Pot Life: | 2 hours at 20°C |
| Overcoatable: | After 8 hours minimum to 14 days maximum at 20°C |
| Dry Film Thickness (DFT): | 100 - 150 microns (4.0 - 6.0 mils) |
| Induction Time: | 10 minutes at 15°C |
