Bradite Fastrac Rust Converter is a high performance single pack water based rust converter, intended for the treatment and passivation of surface rust on all hand or mechanically prepared rusty ferrous surfaces.
Bradite's Fastrac Rust Converter is especially suited for objects which may be difficult to sand blast such as; fences, iron railings, guttering and outdoor fixtures.
- Converts low level corrosion to an inert substrate for painting.
- Water resistant film with good anti-corrosive properties.
- Non-flammable. Low odour.
- Suitable for use on structural steel and machinery.
- Can be applied over slightly damp surfaces.
Application and use should always conform to the codes of practice described in BS 6150 and BS 5493. Brush application is strongly recommended and is the preferred application method for best performance.
Certificates & Approvals
- Manufactured under the auspices of an ISO 9001:2008 quality & ISO 14001:2004 environmental management systems.
- 2004/42/EC EU limit value for this product (cat.A/g wb): 30g/l (2010). This product contains max.29 g/l VOC.
|Finish:||Eggshell (approx. 20%)|
|Stock Colours:||White (turns black on contact with rust)|
|VOC Content:||29 g/L|
|Suitable Substrates:||Steel mechanically prepared to SIS St 3, by wire brush and disc or hand abrading|
|Application Method:||Brush, Roller, Airless Spray or Conventional Air Spraying|
|Theoretical Coverage:||20 m2/L/coat|
|Wet Film Thickness (WFT):||30 microns/coat|
|Dry Film Thickness (DFT):||20 microns/coat|
|Touch Dry:||20-30 minutes at 20°C|
|Overcoatable:||After 3 hours minimum at 20°C|
|Fully Cured:||7 days at 20°C|
|Cleaner / Thinner:||Water|
|Shelf Life:||12 months minimum in original unopened containers|
|Packaging:||Available in 1 Litre|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.