£9.95 delivery on orders excluding certain products & postcodes *
Rustoleum Hard Hat Fluorescent Topcoats 2200 Aerosol are ideal for stenciling and decoration on a number of surfaces, indoors or out. Fluorescent Topcoats 2200 Aerosol Cans come in boxes of 6 and are available in a choice of 5 different vibrant colours, blue, green, red, orange and yellow.
Fluorescent Topcoats 2200 Aerosols are best used for producing a vibrant, fluorescent finish on any surface and can be used with stencils for more accuracy. Fluorescent Topcoats 2200 Aerosols should be used over a white primer or substrate for maximum brightness and and the optimum luminous finish. Fluorescent Topcoats 2200 Aerosol can be used for safety marking and signalling.
Fluorescent Topcoats 2200 Aerosol Cans are available in 500ml tins and offer a coverage rate of 2.1m2 per spray can. Make sure you shake the can well until the rattle ball can be heard after approximately 1 minute and hold 25cm from the surface, shaking vigorously during use. Use a back and forth motion keeping the can parallel with the surface.
Fluorescent Topcoats 2200 Aerosol is a fast drying acrylic resin designed for use in light industrial exposures, normal humidity and interior applications. In an environment of 20°C Fluorescent Topcoats will be tough dry in 15 minutes and is heat resistant for up to 100°C. Use on Walls and floors and other Flat surfaces for the best results and to ensure there are no runs or sags.
Components: | Single Pack |
Type: | Aerosol |
Finish: | Matt |
Stock Colours: | Fluorescent Blue, Fluorescent Green, Fluorescent Red, Fluorescent Yellow and Fluorescent Orange |
Tintable: | No |
VOC Content: | 653 g/l |
Volume Solids: | - |
Suitable Substrates: | Fluorescent Topcoats 2200 Aerosols are best used for producing a vibrant, fluorescent finish on any surface |
Application Method: | Shake the can well until the rattle ball can be heard after approximately 1 minute & hold 25cm from the surface, shaking vigorously during use |
Theoretical Coverage: | 2.1 m² per spray can at 25 μm dry |
Wet Film Thickness (WFT): | 100 μm |
Dry Film Thickness (DFT): | 25 μm |
Induction Time: | - |
Pot Life: | - |
Touch Dry: | 15 minutes at 20°C |
Overcoatable: | After 1 hour at 20°C |
Fully Cured: | 3 days at 20°C |
Cleaner / Thinner: | - |
Shelf Life: | 3 years from date of production unopened cans |
Packaging: | Available in packs of 6 x 500ml aerosols |