£7.75 delivery on orders excluding certain products & postcodes *
Hempel Speed Dry Primer 13770 is suitable as a general purpose primer for protection of steel in mild atmospheric corrosive environments.
New steel: Remove oil and grease etc. thoroughly with suitable detergent. Remove salts and other contaminants by high pressure fresh water cleaning. Abrasive blasting to Sa 2 (ISO 8501-1:2007) is recommended. For temporary protection, if required, use a suitable shopprimer. All damage of shop primer and contamination from storage and fabrication should be thoroughly cleaned prior to final painting. For repair and touch-up use this product.
Repair and maintenance: Remove oil and grease, etc. with suitable detergent. Remove salt and other contaminants by (high pressure) fresh water cleaning. Remove all rust and loose material by abrasive blasting or power tool cleaning. Dust off residues. Touch up bare spots to full film thickness.
Apply using Airless spray/ Air spray/ Brush as via data sheet.
Components: | Single Pack |
Type: | Solvent Based |
Finish: | Flat |
Stock Colours: | 15680 Grey and 50840 Red |
Tintable: | No |
VOC Content: | 386 g/L |
Volume Solids: | 57% |
Suitable Substrates: | For protection of steel in mild atmospheric corrosive environments |
Application Method: | Airless spray, Air spray or Brush |
Theoretical Coverage: | 14.3 m2 per litre at 40 microns |
Wet Film Thickness (WFT): | 60 microns |
Dry Film Thickness (DFT): | 40 microns |
Induction Time: | - |
Pot Life: | - |
Touch Dry: | 30 minutes at 20°C |
Overcoatable: | See data sheet |
Fully Cured: | |
Cleaner / Thinner: | Hempel Thinner 08080 (5%) |
Shelf Life: | 3 years 25°C/77°F from time of production. Store in a closed container. Shelf life is dependent on storage temperature. Shelf life is reduced at storage temperatures above: 40°C/105°F |
Packaging: | Available in 5 and 20 Litres |
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.