International Interline 982 is a two component epoxy holding primer, which can be used a s a blast holding primer, a versatile primer and a fully compatible tank primer.
International Interline 982 is best used as either:
- A blast holding primer, for the temporary protection of freshly blasted steel during the application of tank linings.
- A versatile primer to maximise the effect of dehumidification utilised during the lining of tank internals.
- A fully compatible tank primer which will maintain the optimum performance of the applied tank lining.
All surfaces to be coated should be clean, dry and free from contamination. Prior to paint application all surfaces should be assessed and treated in accordance with ISO 8504:2000. Where necessary, remove weld spatter and smooth weld seams and sharp edges. Oil or grease should be removed in accordance with SSPC-SP1 solvent cleaning.
Abrasive Blast Cleaning
Abrasive blast clean to Sa2½ (ISO 8501-1:2007) or SSPC-SP10. If oxidation has occurred between blasting and application of Interline 982, the surface should be re-blasted to the specified visual standard. Surface defects revealed by the blast cleaning process should be ground, filled, or treated in the appropriate manner.
Thin Film Systems
A sharp, angular surface profile of 50-75 microns (2-3 mils) is recommended.
Heavy Duty Systems & Glass Reinforced Systems
A sharp, angular surface profile of 75-100 microns (3-4 mils) is recommended.
This product is NOT recommended over hand prepared steel.
The following topcoats are recommended for Interline 982:
Consult The Promain Technical team to confirm that Interline 982 is suitable for contact with theproduct to be stored.
|Type:||Epoxy Holding Primer|
|VOC Content:||605 g/lt|
|Suitable Substrates:||Freshly blasted steel|
|Application Method:||Brush, Roller, Airless Spray or Air Spray|
|Theoretical Coverage:||12 m²/litre at 25 microns d.f.t and stated volume solids|
|Wet Film Thickness (WFT):||50-133 microns|
|Dry Film Thickness (DFT):||15-40 microns|
|Pot Life:||8 hours at 15°C|
|Touch Dry:||30 minutes at 15°C|
|Overcoatable:||After minimum 24 hours to maximum 28 days at 15°C|
|Hard Dry:||3 hours at 15°C|
|Cleaner / Thinner:||International GTA220, Clean tools with International GTA822|
|Shelf Life:||12 months minimum at 25 subject to re-inspection thereafter|
|Packaging:||Available in 20 Litres|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.