Jotun Jotamastic 90 GF is a two component polyamine cured epoxy mastic coating that is a surface tolerant, abrasion resistance, high solids, high build product. With reinforced with glass flakes for improved abrasion and scratch resistance.
Jotun Jotamastic 90 GF has been specially designed for areas where optimum surface preparation is not possible or desired. This product provides long lasting protection in environments with high corrosivity. Suitable for use as primer, mid coat, finish coat or as single coat system in atmospheric and immersed environments. Suitable for properly prepared carbon steel, galvanised steel, stainless steel, aluminium, concrete and a range of aged coating surfaces. It can be applied at sub zero surface temperatures.
Primarily designed for maintenance and repair. Specially suitable for surfaces exposed to considerable wear and tear such as high traffic areas.
For carbon steel and shop primed steel prepare to Sa 2. For stainless steel abrasive blast cleaning to achieve a surface profile using approved non metallic abrasive media which is suitable to achieve a sharp and angular surface profile. For aluminium abrasive blast cleaning to achieve a surface profile using approved non metallic abrasive media which is suitable to achieve a sharp and angular surface profile. For galvanised steel light brush blasting using non metallic abrasive leaving a clean, rough and even pattern. For concrete allow a minimum 4 weeks curing. Moisture content maximum 5%. Prepare the surface by means of enclosed blast shot or diamond grinding and other appropriate means to abrade the surrounding concrete and to remove laitance.
Apply using airless spray or brush. Brush is suitable for stripe coating and small areas. Care must be taken to achieve the specified dry film thickness.
|Type:||Polyamine cured epoxy mastic coating|
|Stock Colours:||Grey and Red|
|Tintable:||Selected range of colours tinted over Multicolor Industry tinting system. Please note, bespoke tints are non refundable / exchangeable.|
|VOC Content:||233.0g per Litre|
|Suitable Substrates:||Properly prepared carbon steel, galvanised steel, stainless steel, aluminium, concrete and a range of aged coating surfaces|
|Application Method:||Airless Spray, Use Brush for Stripe Coating and Small Areas|
|Theoretical Coverage:||4 -2.7 m2 per litre per coat|
|Wet Film Thickness (WFT):||250 - 375 microns|
|Dry Film Thickness (DFT):||200 - 300 microns|
|Pot Life:||2 hours at 23°C|
|Touch Dry:||12 hours at 10°C|
|Overcoatable:||20 hours at 10°C|
|Fully Cured:||14 days at 10°C|
|Cleaner / Thinner:||Jotun Thinner No. 17|
|Shelf Life:||48 months|
|Packaging:||Available in 20 Litres|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.