Jotun Penguard HSP ZP

A 2 pack amine cured epoxy coating for new construction where short dry to handle and over coating times are required.

Available in 20 Litres

* These colours are for guidance only. Variations between output devices can misrepresent the appearance of an actual colour. Also, we strongly advise that you order your complete paint requirements simultaneously to ensure a uniform batch colour.

2. Size

3. Select a Qty

As low as:

£163.20

Inc VAT £195.84

PRODUCT DETAILS

Jotun Penguard HSP ZP is a two component amine cured epoxy coating that is fast drying, zinc phosphate pigmented, high solids, and high build. Specially designed for new construction where short dry to handle and over coating times are required.

Best Uses

Jotun Penguard HSP ZP is formulated for use as a primer in atmospheric environments. Suitable for properly prepared carbon steel substrates. Suitable for structural steel and piping to be exposed to corrosive environments. Recommended for power plants, airports, buildings, refineries and mining equipment.

Designed as a primer for Jotun's Steelmaster intumescent thin film passive fire protection coatings.

Application

To secure lasting adhesion to the subsequent product all surfaces shall be clean, dry and free from any contamination. Optimum performance, including adhesion, corrosion protection, heat resistance and chemical resistance is achieved with recommended surface preparation.For Carbon Steel, prepare to Sa 2.5. For Shop Primed Steel, prepare via abrasive sweep or alternatively blasted to Sa 2 (ISO 8501-1) of at least 70 % of the surface. For Coated Surfaces, clean, dry and undamaged compatible coating (ISO 12944-4 6.1).

Apply via airless spray. Use a brush for stripe coating and small areas. Care must be taken to achieve the specified dry film thickness.

TECHNICAL

Approvals

Tested and approved as primer for Jotun Steelmaster thin film intumescent coatings

Technical Info

Components:	Two Part
Type:	Amine cured epoxy coating
Finish:	Matt
Stock Colours:	Red
Tintable:	No
VOC Content:	246.0g per Litre
Volume Solids:	73%
Suitable Substrates:	Suitable for properly prepared carbon steel substrates
Application Method:	Airless Spray. Use a Brush for stripe coating and small areas
Theoretical Coverage:	3 - 12 m2 per litre
Wet Film Thickness (WFT):	85 - 340 microns
Dry Film Thickness (DFT):	60 - 250 microns
Induction Time:	-
Pot Life:	2 hours at 23°C
Touch Dry:	2 hours at 10°C
Overcoatable:	4 hours at 10°C
Fully Cured:	8 days at 10°C
Cleaner / Thinner:	Jotun Thinner No. 17
Shelf Life:	24 months
Packaging:	Available in 20 Litres