Jotun Pilot II

SKU
id17032
UN1263 (Class: 3, Pk Grp: III)
A single component oxidatively drying alkyd coating for engines, topside, deck and superstructure.
Available in 5 Litres and 20 Litres. Tintable to most BS4800 and RAL colours.
From £42.34 £35.28
In stock
Only %1 left
Product Description

Jotun Pilot II is suitable for industrial structures, can also be used for touch up purposes, or in marine environment such as engines, topside, deck and superstructure.

Jotun Pilot II is a one component oxidatively drying alkyd coating. It has a gloss finish with good gloss retention, and can be used as topcoat in atmospheric environments.

Best Uses

Available in most BS4800 and RAL Colours, Jotun Pilot II is suitable for application to a wide range of industrial structures. Various primers and topcoats can be used in conjunction with this product although you should contact us for a better understanding of which coatings you can use in which exposures. This product can be used for touch up purposes, or as recommended for use in the marine environment, can be applied to engines, topside, deck and superstructure.

Application

Jotun Pilot II should be applied using airless spray or conventional spray, however can be applied using a brush or roller if care is taken to achieve the specified dry film thickness. Extra care must be taken to ensure the surface is clean, dry and free from any contamination, which will help to secure lasting adhesion. When applied at a dry film thickness of 40 microns, Jotun Pilot II has a theoretical coverage rate of 12m2 per litre.

Surface and Environment

As part of the Jotun range, Pilot II is suited for application in a variety of areas exposed to atmospheric conditions. Recommended for touch-up purposes and suitable for a wide range of industrial structures to ensure protection and lasting adhesion. Apply Jotun Pilot II over most alkyd, epoxy or vinyl coatings depending on the actual exposure of the coating system.

Technical Details

Approvals

  • Low flame spread certificate according to IMO/Solas directive. Grain, Newcastle Occupational Health
  • Food, Compliant with USA, FDA Title 21, Part 175.300 for dry solids

Technical

Components: One Part
Type: Oxidatively drying alkyd coating
Finish: Gloss
Stock Colours: -
Tintable: Tintable to RAL and BS Colour codes. Please note, bespoke tints are non refundable / exchangable.
VOC Content: 421.0g per litre
Volume Solids: 48%
Suitable Substrates: Compatible previously coated surfaces
Application Method: Airless Spray, Air Spray, Brush or Roller
Theoretical Coverage: 16 - 9.6m2 per litre
Wet Film Thickness (WFT): 60 - 105 microns
Dry Film Thickness (DFT): 30 - 50 microns
Induction Time: -
Pot Life: -
Touch Dry: 4 hours at 10°C
Overcoatable: 24 hours at 10°C
Fully Cured: -
Cleaner / Thinner: Jotun Thinner No. 2
Shelf Life: 48 months
Packaging: Available in 5 Litres and 20 Litres

The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.

Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.

Recommended products to use