Tikkurila Anti Reflex White 2

Tikkurila Anti-Reflex White 2 is a white, anti-reflex, waterborne, high quality, deep matt latex paint for interior ceilings. 

Thanks to unique composition of titan compound and function fillers paint eliminates the light reflex which gives the feeling of the uneven surface. Tikkurila Anti-Reflex White 2 is designed for decorative-protective painting of interior ceilings inside residential, office and public use buildings, including schools and educational and health care premises (hospitals, clinics – with exception of premises that require disinfection or maintain aseptic), schools, kindergartens, nurseries and workhouses and production plants and also food industry without direct contact with food. It emits neutral smell during application and drying. It creates uniform deep matt surface which is resistant to delicate washing.

Best Uses

Tikkurila Anti-Reflex White 2 is designed for painting of ceilings in interior buildings. It can be used for painting of previously painted surfaces with dispersion paints. It is good for painting putty surfaces, plaster, fireboard, chipboard and plaster facing and fibreglass wall papers and this type of materials. Products is good also for decorative painting of concrete. It is ideal choice for: living rooms, kids rooms, bedrooms, dining rooms, hotels, hallways and in offices and public areas. It is recommended for painting of large area and large lighting ceilings, creates fully matt and anti-reflex small-grained surface.

• Anti-reflex properties optically eliminate the surface imperfections
• Uniform deep matt surface irrespective of light dropping angle
• Durable white, UV/UVC resistant
• No streaks and stripes on the surface
• Very good hiding power
• Non-dripping/splashing formula.
• Wet Scrub Resistant: 2 class (according to PN-EN 13300)
• Low VOC content, below the required norm
• Neutral smell during painting.

Application

All surfaces intended for coating must be dry, air temperature may not be lower than +5°C and not higher then +25°C, relative air humidity below 80%.

Surface preparation
Unpainted surfaces (putty surfaces, plaster, concrete and chipboards, fibreboards and gypsum boards): clean these surfaces from dust and loose particles. Prime with Tikkurila Optiva Primer or Tikkurila Anti-Reflex white 2 thinned with water up to 20%. Previously painted surfaces with dispersion, alkyd and oil paints:Wash the surface before painting and remove grease. Remove flaking fragments, sand the surface and clean with water. Sand glossy surfaces with mid-grained sanding paper. Clean the surface
with water and let to dry.

Surfaces painted with glue or lime paint: Remove thoroughly the lime or glue paint till the plaster. Smooth out irregularities and losses with putty. Prime the whole surface with Tikkurila Optiva Primer or Tikkurila Anti-Reflex white [2] thinned with water up to
20%.

Spackling and filling the losses: It is recommended to check if the used putty is strong and stable surface – if after delicate hand wipe the putty is falling or leave the dust on hand then it means that the surface is loose and it has to be primed with Tikkurila Suprabilit. On the previously painted surfaces please make a test painting on the small surface. The positive effect of the test decide on the use of the product.

Notice: Don’t start application if the surface temperature is lower than +5°C.

Top coating
To achieve the surface with required parameters it is recommended to paint it with 1-2 coats. It is recommended to use ANZA painting tools.