Centrecoat Imprinted Driveway Sealer

Centrecoat Imprinted Driveway Sealer is a single pack, solvent borne, acrylic resin based, sealer for imprinted driveways and paving.

Best Uses

When applied to imprinted driveways, this sealer functions as a curing membrane, reducing any tendency towards drying shrinkage cracks. At the same time, the surface becomes sealed against the ingress of oils and many aqueous chemicals, and a harder wearing floor is produced.

• Easily applied by brush, roller or spray
• Single pack – ready to use
• Good chemical and abrasion resistance
• Seals and dust-proofs the surface
• Resistant to UV radiation
• Provides easily cleanable driveway surface
• Suitable for internal and external use

This product can also be used as a curing/sealing treatment to new concrete, and as a sealing/dust-proofing treatment to old concrete and blocks to provide a sealed and dust-proof surface with resistance to the ingress of oil, petrol and chemical spillages.

Application

Imprinted driveways should be sound and free from oil, grease, laitance and other contaminants. Previously applied paint or curing membrane must be removed. Wash the floor with a detergent followed by a clean water wash, and then allow to dry prior to sealer application.

On old concrete, apply a coat of Centrecoat Imprinted Driveway Sealer by brush, roller, squeegee or spray at a nominal rate of 8-9m²/litre. Avoid the formation of puddles of excess material. After a minimum of 12 hours, a second coat shall be applied at a rate of 11-12m²/litre. NOTE: on very porous substrates, a third coat may be necessary.