Centrecoat Multi Surface WB
Centrecoat
Multi Surface WB is a high quality water-based sheen finish that has shown proven adhesion to a wide variety of difficult to paint substrates such as galvanised metal, GRP, some rigid plastics, Plastisol and more.
Available in most BS4800 and RAL Colours
Best Uses
Centrecoat Multi Surface WB is ideally suited for application within the modular building and container industries onto substrates such as carbon steel, galvanised steel (new and weathered), aluminium (including untreated), Plastisol sheeting, pre-painted surfaces, glass, ceramic tiles, GRP and certain rigid plastics.
Centrecoat Multi Surface WB is a non-toxic, lead free environmentally friendly waterborne coating that contains no ingredients that are classified as being hazardous to the environment.
Application
This product must be applied and dried at temperatures above 12°C for best results, and the temperature of the substrate must remain at least 3°C above the dew point at all times during application and the drying process. In cold weather, steel etc should be given time to reach room temperature if brought from outdoors.
Adequate surface preparation is vital in the case of water based coating systems. All surfaces should be clean, dry and free from any form of contamination. It is strongly recommended that all surfaces to be painted are thoroughly washed and dried, and that all remaining surface contamination (such as oil /grease) be removed with a suitable degreasing solvent before preparing the surface. Failure to correctly prepare the surface could result in poor intercoat adhesion or delamination of the paint system. Glossy finishes should be given particular attention and should be adequately abraded, where possible, to provide a good key for any subsequent coating to be applied.
Mix thoroughly before use. Where appropriate, apply a full even coat followed by a second coat after the first coat has surface dried. Can be applied by a variety of application methods, including airless spray or air assisted airless spray (13-15 thou tip). NB. Not recommended for hot spray or electrostatic application.
| Components: | Single Pack |
| Type: | Water Based |
| Stock Colours: | 08-E-51, Ashtead Green, RAL 1014, RAL 7043, RAL 9010, Solar White |
| Tintable: | Yes, to most RAL or British Standard codes on request. Please note, bespoke tints are non refundable / exchangeable |
| Suitable Substrates: | Substrates such as carbon steel, galvanised steel (new and weathered), aluminium (including untreated), Plastisol sheeting, pre-painted surfaces, glass, ceramic tiles, GRP and certain rigid plastics. |
| Cleaner / Thinner: | Supplied ready for use, but if thinning is necessary then do not exceed 5% clean water. All brushes, spray guns etc should be cleaned immediately after use thoroughly with water before the paint has dried on them. Solvent will be required to remove any dried on paint such as spray tips etc. |
| Shelf Life: | 6 months dependent on temperature and conditions. |
| Packaging: | Available in 5 Litres |
| Application Method: | Airless or Air Assisted Spray |
| Theoretical Coverage: | 12m2 per litre when applied to give a dry film thickness of 35 microns. |
| Finish: | Semi Gloss Sheen |
| Touch Dry: | 30 minutes at 20°C |
| Fully Cured: | 7 days at 20°C |
| Volume Solids: | 42% |
| Dry Film Thickness (DFT): | 35 microns |
| Dry to Handle: | 1 hour minimum at 20°C |
