Remmers Betofix R2 is a factory-mixed, highly modified, fast repair mortar that is ready to use after mixing with water and sets hydraulically. Versatile and reliable fast repair mortar for repairing superficial damage on concrete.
Betofix R2 is best used for fast concrete repairs in façade areas. It is ideal for repairing superficial damage on concrete, reinforced concrete and light-weight concrete, as well as mineral corrosion protection for reinforcement steel (with Remmers Rust Inhibitor M, Art. No. 0919). This can also be used for closing broken out areas, pipes, pores, unevenness and gravel pockets, and is suitable for both indoor and outdoor use.
At the time of application the substrate must be dry to matt damp, sound and load-bearing. Remove loose material that could interfere with adhesion and cement grout by sandblasting, bush hammering, milling or similar treatment. The substrate must also be sufficiently rough. The pull-off strength of the substrate must correspond to the relevant technical rules. The pre-wet substrate should be still slightly absorbent.
De-rust exposed reinforcement steel to blank metal SA 2 ½ and remove dust and grease. If there are deeper broken out areas, the adhesive pull strength of the sub-strate should be at least 1.5 N/mm².Then mix 2 parts by weight Betofix R2 with 0.9 parts by weight Remmers Rust Inhibitor M until a homogeneous brushing consistence has been achieved.
Ratio by volume: 2 parts by volume dispersion + 2.5 parts by volume powder.
Coat the entire surface of the steel reinforcement with the freshly mixed corrosion inhibiting grout at least 1 mm thick. Apply a second coat of fresh corrosion inhibiting grout after a waiting time of at least 30 minutes. After a further 30 minutes, the broken out area can be closed with Betofix R2.
- Initially set mortar cannot be made workable again by adding water or fresh mortar.
- Do not use if the temperature of the air, substrate and building material is below +5 °C or above +25 °C.
- May contain traces of pyrite or iron sulphide.
- Protect the repaired areas from drying out too quickly in direct sunlight or drafts.
- Reaction to fire: Class E
|Suitable Substrates:||Concrete, Pipes, Pores and Gravel Pockets|
|Application Method:||Mix with paddle mixer and apply with a filling knife or trowel|
|Theoretical Coverage:||Approx. 1.4 kg/m²/mm thick layer|
|Wet Film Thickness (WFT):||-|
|Dry Film Thickness (DFT):||-|
|Induction Time:||20 minutes at 20°C|
|Touch Dry:||60 minutes at 20°C|
|Overcoatable:||Within 24 hours at 20°C|
|Fully Cured:||Flexural Strength, after 28 days: approx. 5 N/mm²|
|Cleaner / Thinner:||-|
|Shelf Life:||At least 12 months stored dry in closed buckets/bags|
|Packaging:||Available in 25 Kg|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.