Jotun Jotamastic Smart Pack

SKU
id17006
Part A and B: UN1263 (Class: 3, Pk Grp: III)
A 2 pack high build anti-corrosive epoxy mastic which can be applied in high film thicknesses for smaller maintenance and repair jobs.
Available in 10 Litres
From £130.04 £108.37
In stock
Only %1 left
Product Description

Jotun Jotamastic Smart Pack is a two component amine cured epoxy mastic coating that is a surface tolerant, high solids, high build coating.

Best Uses

Jotun Jotamastic Smart Pack is specially designed for areas where optimum surface preparation is not possible or desired. Provides long lasting protection in environments with high corrosivity. Can be used as primer, mid coat, finish coat or as single coat system in atmospheric and immersed environments. Suitable for properly prepared carbon steel, galvanised steel, stainless steel, aluminium, concrete and a range of aged coating surfaces.

General: Primarily designed for smaller maintenance and repair jobs.
Marine: Outside hulls, exterior and interior areas, including water ballast tanks.
Protective: Recommended for offshore environments, refineries, power plants, bridges, buildings, mining equipment and general structural steel.

Application

Specially designed for application with brush and roller. 1:1 mixing ratio for easy use and reduced wastage. To secure lasting adhesion to the subsequent product all surfaces shall be clean, dry and free from any contamination. Suitable for application onto carbon steel, stainless steel, galvanised steel, previously coated surfaces and concrete. Apply using airless spray, round brush or foam rollers. Foam rollers will give the best results.

Technical Details

Approvals

  • Grain, Newcastle Occupational Health
  • Low flame spread certificate according to IMO FTPC Part 5 (IMO Res. A.653(16)) / IMO FTPC Annex 2 Item 2.2
  • Norsok M-501 System 1 (Pre Qualified)

Technical Info

Components: Two Part
Type: Amine cured epoxy mastic coating
Finish: Semi Gloss
Stock Colours: Black, Buff, Green, Grey, Red
Tintable: No
VOC Content: 255.0g per litre
Volume Solids: 75%
Suitable Substrates: Carbon steel, galvanised steel, stainless steel, concrete and a range of aged coating surfaces
Application Method: Airless Spray, Round Brush or Foam Roller
Theoretical Coverage: 14.9 - 6.2m2 per litre
Wet Film Thickness (WFT): 50 - 120 microns
Dry Film Thickness (DFT): 67 - 160 microns
Induction Time: -
Pot Life: 1.5 hours at 23°C
Touch Dry: 7 hours at 10°C
Overcoatable: 14 hours minimum at 10°C
Fully Cured: 10 days at 10°C
Cleaner / Thinner: Jotun Thinner No. 17
Shelf Life: 24 months
Packaging: Available in 5 Litres

The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.

Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.

Recommended products to use