*Jotun Pilot WF SM
Please note, this product is now discontinued. Contact our technical team for a suitable alternative.
Jotun Pilot WF SM is a single pack, water borne acrylic emulsion topcoat for use over Jotun intumescent systems.
Best Uses
Jotun Pilot WF SM is a versatile, fast drying product for interior use. It provides a semi-gloss finish with good colour and gloss retention and dries down to 10°C. Ideal for new construction or maintenance where fast dry to handle and over coating times are required. Jotun Pilot WF SM is suitable for use as topcoat in atmospheric environments. Part of a complete water borne system with a recommended Jotun water borne primer and SteelMaster WF products.
Developed mainly for use on intumescent products (SteelMaster). Should be applied on-site and is best suited for indoor environment.
This product is tintable in a wide range of colours. Provides dry atmospheric heat resistance continuously at 70°C. Able to withstand a peak of 80°C.
Depending on the actual exposure of the coating system, various acrylic and epoxy primers and topcoats can be used in combination with this product.
If you require a detailed coating specification please contact our Technical Team.
IMPORTANT INTUMESCENT PRODUCT NOTE: Always contact Promain’s technical team prior to purchase to obtain a tailored project specification and the advice necessary. The information displayed on this website should only be used as a guide. Promain UK Limited will not be held liable for any resulting damage to property, human life or monetary costs incurred due to incorrect specification, preparation, application or maintenance that has occurred due to negligence by either the purchaser or applicator. This includes your failure to have contacted us to obtain the relevant advice/specification.
Application
Suitable for application over coated surfaces in a Jotun system. Ensure the substrate is clean, dry and undamaged compatible
coating. Apply via airless spray. Brush is recommended for stripe coating and small areas, care must be taken to achieve the
specified dry film thickness. If applying by roller use a suitable roller. However, when using roller application care must be taken to apply sufficient material in order to achieve the specified dry film thickness.
The product MUST NOT be thinned. Refer to the Application Guide before commencing preparation / coating.
| Components: | Single Pack |
| Type: | Waterborne Acrylic Emulsion |
| Finish: | Semi Gloss |
| Stock Colours: | Just tints |
| Tintable: | Yes, to most RAL or British Standard codes. Please note, bespoke tints are non refundable / exchangeable |
| VOC Content: | 89 g/L |
| Volume Solids: | 45% |
| Suitable Substrates: | Topcoat over intumescent Jotun products. |
| Application Method: | Use airless spray. Brush and Roller |
| Theoretical Coverage: | 5.6 - 11.3 m2 per litre |
| Wet Film Thickness (WFT): | 89 - 178 microns |
| Dry Film Thickness (DFT): | 40 - 80 microns |
| Induction Time: | - |
| Pot Life: | - |
| Touch Dry: | 20 minutes at 10°C |
| Overcoatable: | After 3 hours minimum at 10°C |
| Fully Cured: | |
| Cleaner / Thinner: | Water |
| Shelf Life: | 12 months in original unopened containers. |
| Packaging: | Available in 5 and 20 Litres |
