£7.75 delivery on orders excluding certain products & postcodes *
PPG Steelguard 651 can be used in the following segments:
Steelguard 651 is suitable for C1, C2 and C3 internal environments (ISO 12944); for dry internal (C1) environments no topcoat is required.
Approved primer must be sound, dry and free from any contamination.
The recommended application method is with an airless spray. Stir thoroughly until homogenous and free of lumps. Note that adding too much water will result in reduced sag resistance and slower cure.
Components: | Single Pack |
Type: | Waterborne Intumescent Coating |
Finish: | Matt |
Stock Colours: | White |
Tintable: | No |
VOC Content: | max. 0.2 g/kg |
Volume Solids: | 70 +/- 3% |
Suitable Substrates: Steelwork | |
Application Method: | Airless Spray. Brush or Roller should only be used on small areas (touch up and repair) |
Theoretical Coverage: | 1.00 m2/l for 700 microns |
Wet Film Thickness (WFT): | - |
Dry Film Thickness (DFT): | 200 - 700 microns (8.0 - 28.0 mils) per coat |
Induction Time: | - |
Pot Life: | - |
Touch Dry: | 2 hours at 20°C |
Overcoatable: | After minimum of 16 hours at 20°C |
Fully Cured: | - |
Cleaner / Thinner: | Tap water (normally no thinner required) |
Shelf Life: | 12 months from date of production unopened |
Packaging: | Available in 20 Litres |