*Rust-Oleum Trade Ultra Scrubbable Matt *CLEARANCE*

Please note, this product has been discontinued. however, we have a small supply still available. Grab a bargain today!

See Mapei Dursilite as a potential alternative.

Rustoleum Ultra Scrubbable Matt is a multi-purpose matt wall and ceiling paint. Particularly suitable for painting walls and ceilings in large-scale new construction and renovation projects.

Best Uses

Rustoleum Ultra Scrubbable Matt is a multi-purpose matt wall paint based on an acrylic dispersion. Scrub-resistant, Class 1. Easily applicable and good coverage. Particularly suitable for painting walls and ceilings in large-scale new construction and renovation projects. For interior use and protected exterior surfaces.

Ideal for contractor or trade use.

Rustoleum Ultra Scrubbable Matt is suitable surfaces include: existing coats of wall paint, cement and plasterwork, concrete, brick, gypsum panelling, board, etc. Also suitable for painting glass fibre fabric.

• Scrub-resistant, Class 1 (DIN EN 13300)
• Good coverage
• Virtually odour-free
• For interior use and protected exterior surfaces
• Matt

Application

The surface must be capable of supporting the paint, completely set, clean, dry, and free from dust or grease. Sand and repair surface irregularities. Remove and/or repair all loose and unstable coats. In the case of exterior applications, remove all moss, mould and algal growth.

For new, untreated substrates

• Prime highly absorbent surfaces in their entirety using Stabilising primer.
• Thoroughly clean powdery surfaces. Prime using Stabilising primer after allowing to dry.
• Paint to cover after allowing to dry.

For existing intact coats of wall paint

• Clean using paint cleaner.
• Apply an intermediate coat of Wall Primer Opaque if necessary.
• Apply the top coat after allowing to dry.

For existing, non-load-bearing coats of wall paint

• Remove loose parts.
• Thoroughly wash powdery coats and allow them to dry.
• Carry out any repairs.
• Prime with Stabilising primer.
• Apply the top coat after allowing to dry.

For areas with contamination caused by nicotine, damp, rust or soot

• Clean thoroughly using Paint cleaner.
• Treat surface/stain with sealing primer.
• Apply the top coat after allowing to dry.

The systems described above apply for the most common types of surface. For specific applications and / or detailed advice, please contact our technical team.

Stir thoroughly prior to use. The first coat can be diluted with a maximum of 10% water. Apply in 1 or 2 coats using a suitable brush, paint roller or paint sprayer. Always work wet-on-wet to prevent visible brush strokes. Back-roll all overlaps in the same direction. Do not touch up when drying.