Sherwin Williams Resuflor HB

Sherwin Williams Resuflor HB is a two-pack solvent-free high-performance clear floor coating. Suitable for high end chemical, hygienic food and beverage floors, aviation and automotive floors.

Formerly Resutop Clear / Resucoat HB.

Best Uses

Sherwin Williams Resuflor HB is based on high solids epoxy resin technology which is formulated to provide a tough and durable floor protection finish.

Suitable for application in a variety of thicknesses for a wide range of applications. The coating will provide smooth gloss finish to which anti-slip aggregate can be added if required. Resuflor HB Clear is easy to apply by roller, squeegee and paint brush to create a seamless, hard wearing and hygienic floor finish.

• High-build clear finish
• High solids
• Hygienic and easily cleaned
• Good colour stability
• Provides excellent anti-slip with addition of aggregate
• Ease of application
• Low odour
• Excellent adhesion
• Solvent free

Recommended for use within the food processing and beverage industry, chemical plant rooms, engineering workshops, aviation and automotive factory floors.

Also ideal for warehouses and excellent for all floor demarcation and walkways.

See Sherwin-Williams Resuflor Deco System Guides for recommended floor systems.

Application

Preparation

New Concrete Floors: New concrete must be clean, sound, dry, fully cured and surface laitance removed by vacuum enclosed shot blasting or mechanical grinding, a minimum strength of 25N/mm² is required.

Existing Concrete Floors: Remove all dirt, oil, grease, old paint or any other surface contaminants by vacuum enclosed shot blasting, scarifying or mechanical grinding. Fats, oils or greases must be removed by mechanical means and detergent washing and making sure all residue of detergent is washed and removed by rinsing with clean water. Local repairs should be carried out using Sherwin Williams Resuflor Patch.

Existing Floors (previously coated): All previous coatings and loose floor paints must be removed by mechanical preparation as described in the above section and primed as specified. If the old resin flooring cannot be removed then please consult with our technical team for advice on intercoat adhesion and suitability, as it may not be compatible with the existing floor coating.
Where Resuflor HB Clear is applied to masonry/concrete surfaces, care must be taken to ensure that surface preparation is thorough but does not disfigure the surface.

Priming

Open and porous substrates may require priming with Resuseal WB or Resuprime ST may be used as primer on dry substrates only with less than 75% ERH reading.

Where the Relative Humidity of a substrate exceeds 75% ERH, Resuprime MVT should be specified and selected on the basis of hygrometer readings in accordance with BS 8203. Please refer to the product data sheet for full application details and please refer to recommended individual product data sheets.

Mix the entire contents of the Resuflor HB Clear Base with the Resuflor HB Clear Hardener. If a separate mixing bucket is being used mix thoroughly ensuring all contents of both components are removed from the buckets supplied. Mix using a slow speed electric mixer for approximately two to three minutes until the two components are fully combined.

The mixed unit should be applied immediately by roller, brush or squeegee with a consistent procedure. Floor areas should be cross-rolled to ensure even application and to minimise roller marks.