Teamac 2 Pack Zinc Phosphate Primer is a two pack epoxy anti-corrosive primer for application to steel which is clean and free from scale and / or rust.
Teamac 2 Pack Zinc Phosphate Primer is suitable for marine, agricultural, construction equipment / plant and machinery as an anti-corrosive primer.
Teamac 2 Pack Zinc Phosphate Primer is used for application to blast cleaned and other suitably prepared steel surfaces. It is not suitable for use as a weld through blast primer. Provided the steel has been cleaned effectively an outstanding bond is formed between primer and metal.
Ensure all surfaces are clean, dry and free from grease, oil and any other contaminates. Bare steel should be free from dust, rust and scale. Blast cleaning to SA 2½ is recommended. If blast cleaning is impractical, mechanical cleaning should be employed as hand cleaning does not clean the steel to the required degree. Any oil or grease should be removed with solvent before de-rusting. Where blast cleaning is carried out after assembly, special attention must be paid to edges, corners, nuts, bolts welds, etc. Welds should, if necessary be ground and all weld spatter, slag etc. must be removed.
By volume, mix 3 parts of the base with 1 part of the activator, as the ratio supplied. These should be thoroughly mixed together, preferably by slow speed electric mixer. Ensuring the material is thoroughly mixed is very important - poorly mixed product can lead to soft spots and uncured coatings. Thinning is not normally required for airless spray systems. Use within 4 hours. Clean and flush equipment immediately after use to prevent the paint solidifying in guns, pots and lines.
Can be applied over 2 pack zinc phosphate blast primers which are free from contamination.
|Stock Colours:||Grey and Red|
|VOC Content:||<500 g/L|
|Suitable Substrates:||For application to blast cleaned and other suitably prepared steel surfaces.|
|Application Method:||Brush or Airless Spray|
|Theoretical Coverage:||12 m2 per litre at 44 microns DFT|
|Wet Film Thickness (WFT):||85 - 190 microns|
|Dry Film Thickness (DFT):||44 - 100 microns|
|Touch Dry:||1.5 - 2 hours at 20°C|
|Overcoatable:||Between 2 - 4 hours at 20°C|
|Fully Cured:||3 - 5 days at 20°C|
|Cleaner / Thinner:||Do not thin|
|Shelf Life:||2 years in original unopened containers.|
|Packaging:||Available in 5 Litres|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.