Wethertex CP80 Clad-Seal Metal and Cladding Coating

Wethertex CP80 Clad-Seal Steel & Cladding Coating is a high performance, self priming, exterior quality satin paint for use on a variety of metal substrates.

Best Uses

Developed using advanced Optilife silicone technology, CP80 is quick drying, highly water resistant and offers excellent protection against rust for up to 12 years. Ideal for metal cladding. Chemically resistant.

Application

Preparation

Ensure all surfaces to be painted are clean, dry and free from grease and loose or flaking material that may impair adhesion. Any faults in the substrate, particularly those that can lead to moisture penetration, must be rectified or can affect the finish quality. If your
substrate has been previously painted rub down with a fine waterproof abrasive paper and then rinse thoroughly. Bare substrates should also be abraded in a similar manner to allow improved adhesion. Please avoid inhaling any sanding dust and always wear a face mask if fine sanding. Special precautions should be taken during preparation of pre-1960’s paint surfaces over wood and metal as they may contain harmful lead.

Application

Stir the product thoroughly and do not contaminate. For the best results apply by spray, also can be applied by brush or roller. Application tool type and quality may influence the finished appearance. Apply liberally and avoid overspreading. Not to be applied below 8ºC. Recommended application 2 coats. On bare substrates please thin CP80 with 10% clean water. Under normal conditions will be dry after 1-2 hours, and can add additional coats after 3-4 hours. Ensure good ventilation during drying and application. Do not apply externally when rain or other inclement weather is imminent, ensure substrate is dry.