
Zinga Zingaspray - 500ml Aerosol
Zinga's Zingaspray is a convenient 500ml aerosol with all the advantages of Zinga 96% Zinc Cathodic Protection in a simple hand held aerosol can.
Best Uses
Zingaspray aersols are best used for repairing worn or damaged hot dip galvanising or spot repair on items previously coated with Zinga 96% Zinc Cathodic Protection. Zingaspray aersols offer cold galvanizing paint protection of ferrous metal structures as an alternative to hot dip galvansation or metallisation.
Preparation
For Marine Structures: Remove all growth with a UHP water jet or high pressure wash down. Leave to dry. Blast clean the substrate.
For Old or Worn Galvanising or Repair of Old Zinga: Steam clean to remove contamination from porous surfaces, dry off, blast clean as normal.
For New Steel: Steam clean or high pressure wash down all surfaces. Leave to dry. Blast clean to standard Sa 2.5
New Galvanised Steel: Steam clean substrate. Sweep blast the surface at a blast pressure of 55psi using a 45° nozzle angle to avoid removing any existing zinc thickness.
For Cast Iron: Steam clean or high pressure wash down all surfaces. Leave to dry. Blast clean to standard Sa 2.5
For Aluminium Alloys: Solvent clean as per SSPC-SP1 Standard. Blast clean with aluminium oxide media grade 3. Vacuum surface before application.
Application
One coat of Zingaspray will dry at approximately 20-25 microns. Therefore a minimum of two coats is recommended.
Notes
- Zinga aersols are suitable for the repair of worn or damaged hot dip galvanising or spot repair on items previously coated with Zinga 96% Cathodic Protection.
Technical Info
Components: | One Part |
Type: | Aerosol |
Finish: | Matt |
Stock Colours: | Grey |
Tintable: | No |
VOC Content: | 668.0g per Litre |
Volume Solids: | 16.8% |
Suitable Substrates: | For the repairing and touching-up of damaged or old hot-dipped, Zinganised or other zinc coated structures. |
Application Method: | Aerosol |
Theoretical Coverage: | 4.22 m2 per litre at 40 microns |
Wet Film Thickness (WFT): | - |
Dry Film Thickness (DFT): | 40 microns |
Induction Time: | - |
Pot Life: | - |
Touch Dry: | 15 minutes at 20°C in 40 microns |
Overcoatable: | Always apply 2 layers, apply the second coat 1 hour after touch dry. |
Fully Cured: | 48 hours at 20°C in 40 microns |
Cleaner / Thinner: | - |
Shelf Life: | 2 years unopened |
Packaging: | Available in 500ml Aerosols |