Rustoleum Galva Zinc 2120 500ml Aerosol Spray contains pure zinc and aluminium pigmentation and offers the appearance of a new metallic galvanised steel finish.
Rustoleum Galva Zinc 2120 500ml Aerosol Spray is part of our Metal Primer range, and offers excellent drying time and contains pure zinc and aluminium as pigmentation. Hard Hat Galva Plus Zinc Primer has an appearance similar to new galvanised steel giving the effect of a metallic finish.
Rust-Oleum Hard Hat Galva Plus 2120 Spray is a fast drying zinc/aluminium coating based on an epoxy ester resin. Rustoleum Galva Zinc 2120 500ml Aerosol Spray is intended for use as a single coat in light industrial exposures and corrosive environments and is suitable to use for touching up small areas of galvanised steel surfaces.
Rustoleum Galva Zinc 2120 500ml Aerosol Spray should be shaken vigorously for at least one minute before use until the rattle of mixing is heard. When applying the product make sure you hold parallel to the surface at approximately 25cm away. Keep shaking the can throughout use. Use a back and forth motion when applying the spray. After you have finished your coating you can clean the valve by turning the can upside down and holding the spray button for 3-5 seconds.
Surface/Environment is it designed for?
Rustoleum Galva Zinc 2120 500ml Aerosol Spray is designed for touching up galvanised steel surfaces in light industrial exposures and corrosive environments. Rustoleum Galva Zinc 2120 500ml Aerosol Spray has a theoretical coverage rate of 1.7m2 per can, depending on the surface material.
- This primer contains pure zinc and aluminium as pigments.
- Hard Hat Galva Plus zinc primer has an appearance similar to new galvanised steel.
- Galva Plus should be used as a single coat in light industrial exposures and corrosive environments.
- It resists 310 hours of salt spray testing (DIN 500210 SS).
- Rust-Oleum Hard Hat Galva Plus has lower zinc contents and more aluminium.
|Type:||zinc/aluminium coating based on an epoxy ester resin|
|VOC Content:||655 g/l|
|Suitable Substrates:||Used for touch-up of galvanised steel surfaces|
|Application Method:||Aerosol Spray|
|Theoretical Coverage:||1,7 m² per spray can at 25 μm dry|
|Wet Film Thickness (WFT):||100 μm|
|Dry Film Thickness (DFT):||25 μm|
|Touch Dry:||15 minutes at 20°C|
|Overcoatable:||After 48 hours at 20°C|
|Fully Cured:||7 days at 20°C|
|Cleaner / Thinner:||-|
|Shelf Life:||3 years from date of production unopened|
|Packaging:||Available in 500ml Aerosols|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.