£7.75 delivery on orders excluding certain products & postcodes *
Barrettine ArmourFlex Hardwax Oil provides a resilient, water repellent, and stain resistant finish to all types of interior wood. Available in Matt or Satin finishes in Clear.
Ideal applications for this hard wax floor oil include hardwoods, softwoods, and wood veneer. It can be used on a variety of wood structures, including floors, doors, window frames, furniture, wood turnings and railings. Not certified for food contact applications such as chopping boards.
Before using, test a small inconspicuous area with all products to be applied to ensure a satisfactory final finish and compatibility. Test the colour and compatibility with any wood fillers or dyes on a scrap piece of wood before use.
Not suitable for use over barrier coatings, such as paints, varnishes, or lacquer. These must be removed completely either by sanding, heat gun or paint stripping. If choosing to use paint stripper, either Barrettine Paint Panther or Barrettine Peelaway may
be suitable.
Ensure good ventilation is maintained during application and throughout the drying process. Ready to use, do not thin. Stir thoroughly before use.
Apply in thin coats using either a short pile roller, good quality brush or lint free cloth. Over-application can reduce the finish quality and prolong drying time. On previously treated timber 1 coat is normally sufficient, maximum of 2 coats may be required if applying to fresh or previously untreated timber.
Aftercare and Maintenance
Marks and scratches can be touched up without the requirement for sanding. Ensure areas to be repaired are clean and dry. To renovate large areas, lightly sand with 120-150 grit sandpaper, remove dust and then apply a single, thin coat. Barrettine Armourflex Hardwax Oil imparts a tough, resilient surface to the wood that resists typical daily knocks and scratches. To help retain the best appearance a good level of general care is advised e.g., felt pads on the bottom of furniture. Clean floors regularly with Barrettine Armourflex Wood Floor Cleaner.
Components: | Single Pack |
Type: | Wood Oil |
Finish: | Satin / Matt |
Stock Colours: | Transparent |
Tintable: | No |
VOC Content: | 450-460 g/l |
Volume Solids: | 50% |
Suitable Substrates: | For interior woodwork |
Application Method: | Short pile roller, good quality brush or lint free cloth |
Theoretical Coverage: | Approximately 24-28 m2 per l (One Coat), 12-16 m2/l (Two Coats), depending on substrate absorbency and surface condition (rough/smooth). |
Wet Film Thickness (WFT): | |
Dry Film Thickness (DFT): | |
Induction Time: | - |
Pot Life: | - |
Dust Dry: | 6 - 8 hours at 20°C |
Overcoatable: | Overnight at 20°C |
Traffic Ready | suitable for light foot traffic approximately 16 hours at 20°C after final coat |
Cleaner / Thinner: | Clean tools with white spirit |
Shelf Life: | See container |
Packaging: | Available in 1 and 2.5 Litres |