Carboline Phenoline 353 LT

SKU
id23753
Part A: UN1263 (Class: 3, Pk Grp: II), Part B: UN3469 (Class: 3, Pk Grp: III)
A versatile tank lining suitable for low temperature application down to 2°C. NORSOK 7a Approved.
Available in 10 Litres in Grey
£242.40 £202.00
In stock
Product Description

Carboline Phenoline 353 LT is a highly cross-linked epoxy tank lining with exceptional overall chemical resistance & versatility. Allows application and curing down to 2°C.

Carboline Phenoline 353 LT benefits from a unique blend of resins to make it highly resistant to a variety of aggressive cargos. Carboline Phenoline 353 LT is an ideal tank lining for gasoline, gasoline blends, biodiesel, fuel oils, and others. Suitable for use in both acidic and high temperature caustic exposures.

  • Outstanding overall chemical resistance
  • Dense, highly cross-linked film for superior barrier protection
  • Excellent abrasion resistance and toughness
  • Well-suited for hydrocarbon exposures
  • Cures down to 2°C
  • Meets NORSOK System 7C Requirements for subsea equipment up to 356°F (180°C)

Carboline Phenoline 353 LT is suitable for terminals, refineries, petrochemical, wastewater, railcar linings, subsea oil and gas equipment, and many other markets.

Application

Suitable for application onto steel, concrete or CMU that has been suitably prepared via blast cleaning. Apply via conventional spray, airless spray, or brush / roller for small difficult areas only. See product data sheet for full preparation and application guidance.

Technical Details
Components: Two Pack
Type: Modified Novolac Epoxy
Finish: Gloss
Stock Colours: Grey 0700
Tintable: No
VOC Content: 197 g/L
Volume Solids: 76%
Suitable Substrates: Steel, concrete or CMU
Application Method: Conventional Spray, Airless Spray, or Brush / Roller
Theoretical Coverage: 29.9 m²/l at 25 microns
6.0 m²/l at 125 microns
4.3 m²/l at 175 microns
Allow for loss in mixing and application.
Wet Film Thickness (WFT):  
Dry Film Thickness (DFT): 5 - 7 mils (127 - 178 microns) per coat
Two coats are generally recommended to 10-14 mils (254-356 microns) total DFT.
Total thickness not to exceed 18 mils.
Induction Time: -
Pot Life: 1 hour at 24°C
Surface Dry: -
Overcoatable: Between 12 hour - 7 days at 10°C
Immersion Ready: 10 days at 10°C
Cleaner / Thinner: Use Thinner #2 or Acetone
Shelf Life: 2 years minimum in original unopened containers.
Packaging: Available in 10 Litres

The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.

Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.

Recommended products to use