The application of Centrecoat 2 Pack PU Floor & Driveway Sealer helps to protect the floor surface and ease maintenance by reducing the adhesion of dirt and other debris, whilst eliminating dusting. Centrecoat 2 Pack PU Floor & Driveway Sealer is UV stable and resistant to many of the chemicals commonly found in industrial applications.
Benefits from excellent abrasion resistance and a high bond strength.
Surfaces to be sealed must be clean, dry and free from dust or other debris or contaminants. Centrecoat 2 Pack PU Floor & Driveway Sealer can be used to seal some screeds as soon as 1 hour after the screed has set, dependent on temperature and humidity conditions.
For best results, mix component A with component B for a minimum of 2 minutes using a high speed mixer, such as a drill with paddle attachment. Once mixed, leave to rest for 5 minutes, and then remix to consistency at a slow speed. Prior to application of neat Centrecoat 2 Pack PU Floor & Driveway Sealer, it is recommended that a dilute coat 1:1 Centrecoat 2 Pack PU Floor & Driveway Sealer/Water be applied. This should be followed by 1 or 2 coats of neat Centrecoat 2 Pack PU Floor & Driveway Sealer.
Pour neat Centrecoat 2 Pack PU Floor & Driveway Sealer into a roller tray and, using a roller, apply it evenly over the surface at a rate of approximately 10m² per litre. When applying a second coat of Centrecoat 2 Pack PU Floor & Driveway Sealer, we would recommend that this be applied at an angle of 90 degrees to the first coat to ensure complete coverage. Under typical conditions, a second coat can be applied approximately 1 hour after the first.
When coating a smooth floor, it is recommended to use a short hair mohair roller.
DO NOT POUR DIRECTLY ONTO THE SUBSTRATE.
|Type:||Water dispersed polyurethane|
|Suitable Substrates:||Concrete and driveways|
The first coat of Centrecoat 2 Pack PU Floor & Driveway Sealer should be applied diluted 1:1 with water, and subsequent coats should be applied neat. Typical coverage of the first coat is approximately 10m2 per litre of diluted material, and the typical coverage of subsequent coats is 10m2 per litre of neat material.
|Wet Film Thickness (WFT):|
|Dry Film Thickness (DFT):|
|Pot Life:||4 hours at 20°C|
|Foot Traffic Ready:||6 hours at 20°C|
|Fully Cured:||3 days at 20°C|
|Cleaner / Thinner:||Once mixing, application and finishing are complete, tools can be cleaned with warm soapy water.|
|Shelf Life:||Approximately 12 months if stored in unopened containers and under good conditions.|
|Packaging:||Available in 5 Litres|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.
A trade quality fibreglass and aluminium pole that can withstand the heavy duty use of applying paint or cleaning floors.