Centrecoat Drive Seal is a single pack, solvent borne, acrylic resin based, surface sealer and dust proofer for concrete and block paving.
When applied to freshly placed concrete, Centrecoat Drive Seal functions as a curing membrane, reducing any tendency towards drying shrinkage cracks.
By using Centrecoat Drive Sealer, the surface will become sealed against the ingress of oils and many aqueous chemicals, and a harder wearing floor is produced. When applied onto old concrete or blocks, Centrecoat Drive Seal penetrates into the pore structure thereby sealing and dust-proofing the surface.
- Easily applied by brush, roller or spray.
- Single pack – ready to use
- Good chemical and abrasion resistance
- Seals and dust-proofs the surface
- Resistant to ultra violet radiation
- Provides easily cleanable floor surface
- Internal and external use
Centrecoat Drive Seal benefits from a high resistance to the ingress of oil, petrol and chemical spillages.
Old concrete and block paving shall be sound and free from oil, grease, laitance and other contaminants. Previously applied paint or curing membrane must be removed. If required, wash the floor with a detergent followed by a clean water wash, and then allow to dry prior to sealer application.
For new concrete – Centrecoat Drive Seal may be applied 15 minutes after the final power float or brush finish, or at any appropriate time thereafter.
Old concrete – Apply a coat of Centrecoat Drive Seal by brush, roller, squeegee or spray at a nominal rate of 8-9m2 per litre. Avoid the formation of puddles of excess material. After a minimum of 12 hours a second coat shall be applied at a rate of 11-12m2 litre. NOTE: on very porous substrates a third coat may be necessary.
New Concrete – Apply Centrecoat Drive Seal by spray at a nominal rate of 5m2 per litre. Ensure that the material is applied evenly and avoid the formation of
puddles of excess material on the surface. In hot and/or windy conditions, a second coat of Centrecoat Drive Seal should be applied at a rate of 8-10m2 per litre.
Block Paving – Ensure material is applied to fully seal the surface. Coverage is dependent on the porosity of the block.
|Stock Colours:||Clear (Pale Straw Colour)|
|Suitable Substrates:||Concrete, Block Paving.|
|Application Method:||Brush, Roller, Squeegee or Spray|
|Theoretical Coverage:||Depending on Application Method|
|Wet Film Thickness (WFT):|
|Dry Film Thickness (DFT):|
|Pot Life:||25 - 30 minutes at 20°C|
|Tack Dry:||2 - 4 hours at 20°C|
|Hard Dry:||24 hours at 20°C|
|Cleaner / Thinner:||Centrecoat MMA Tool Cleaner|
|Shelf Life:||12 months minimum in original unopened containers.|
|Packaging:||Available in 5 Litres|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.