Centrecoat Epoxy Paste Adhesive

Centrecoat Epoxy Paste Adhesive is a thixotropic, solvent free epoxy adhesive ideal for bonding a wide range of building materials to one another e.g. concrete, brick, metal, stone and wood. Apply when necessary prior to Centrecoat Polyaspartic Line Marking 30.

Best Uses

Centrecoat Epoxy Paste Adhesive has a high level of mechanical integrity and exhibits excellent bonding characteristics even under damp conditions. Easy to mix & apply. Requires no primer.

When applying Centrecoat Polyaspartic Line Marking 30, Centrecoat Epoxy Paste Adhesive should be used to make good blow holes & defective concrete. Alternatively, Centrecoat MMA Repair Mortar can be used.

• Excellent adhesion to most building materials
• Bonds to damp substrates
• Low odour
• Thixotropic nature facilitates application in both vertical and overhead locations
• Very good chemical properties and cohesive strength
• Resistant to water, weathering and a wide range of chemicals
• No primer required
• Creep resistant

Application

Concrete substrates shall be sound, clean and free from dust, dirt, grease, oils, laitance and other contaminants. A roughened or profiled surface will ensure optimum adhesion.Mild steel and other metallic substrates shall be degreased, power wire brushed or grit blasted and vacuumed free from dust. Other substrates shall be sound, clean and free from dust, dirt, grease, oil and any oxidised surface layer.

The Base and Curing Agent components shall be thoroughly mixed together using a stiff spatula or a slow speed drill with paddle attachment until a uniform grey mixture has been produced. Aplication is best achieved using a spatula, trowel, serrated trowel or stiff bristled brush depending on the area to be treated.

Bonding Surfaces Together
Apply to each of the two surfaces to be bonded. The surfaces are then pushed together to achieve the required bond thickness. Excess adhesive should be removed and the joint protected from movement until the resin has set.

Patch Repairs
Scrape or ‘knife in’ the Centrecoat Epoxy Paste Adhesive and finish with trowel, palette knife or spatula.

Note: For more inaccessible areas, Centrecoat Epoxy Paste Adhesive may be placed into empty cartridges and injected/‘gunned’ into place using a standard sealant gun.