Centrecoat Polyurethane Floor Paint is resistant to splashing with petrol, lubricating oils, mild alkalis, dilute mineral acids (including battery acids), grease and water. Provides a smooth finish with a high sheen.
This single pack durable floor paint is ideal for garages and small warehouses.
Concrete should be clean, dry and free from dust, dirt, grease and other contaminates etc. All surfaces to be coated should be dry (the concrete should have a moisture content below 6%. Power–floated floors should be abraded/acid etched to provide a key for the coating.
For Previously Painted Floors:
As with all coating applications, suitable pre-treatment of the floor is of the utmost importance. Old paint especially with suspect adhesion or of an unknown type should be completely removed. Some paints however may still lift, be softened, or cause poor inter-coat adhesion when this system is applied on top of them. So, it is always advisable to check for suitability and defects by undertaking small-scale trials. If the old paint is satisfactory, clean and abrade the surface in the normal way.
For Heavily Contaminated Floors:
Centrecoat Polyurethane Floor Paint will not adhere satisfactorily to heavy deposits of grease, oils etc. It will be necessary to mechanically abrade the floor to remove the excess contamination.
For New Floors/Uncoated Surfaces:
For most surfaces two coats should be sufficient. The first coat should be thinned 20%-30% to act as a sealer using Centrecoat HB Anti-Corrosive Cladding Paint Thinners. This should be followed by one or two coats of the Centrecoat Polyurethane Floor Paint (unthinned). It is important to allow overnight drying between the coats. Apply via brush or roller.
|Finish:||High sheen (available in a Matt finish, subject to minimum order quantity)|
|Tintable:||Yes, to most RAL or British Standard codes. Please note, bespoke tints are non refundable / exchangeable|
|Suitable Substrates:||For concrete floors|
|Application Method:||Brush or Roller|
|Theoretical Coverage:||Expected coverage is 8m2 per litre. This will depend on the film thickness applied, the surface profile and the porosity of the floor being painted.|
|Wet Film Thickness (WFT):|
|Dry Film Thickness (DFT):||30 - 50 microns per coat|
|Touch Dry:||3 hours at 20°C|
|Foot Traffic:||Overnight at 20°C|
|Fully Cured:||7 days at 20°C|
|Cleaner / Thinner:||Centrecoat HB Anti-Corrosive Cladding Paint Thinners|
|Shelf Life:||12 months when stored indoors in original unopened containers and not subjected to extremes of temperature. Mix thoroughly before use.|
|Packaging:||Available in 5 Litres|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.
Formulated for thinning and cleaning up alongside our Centrecoat HB Anti-Corrosive Cladding Paint.
Anti-slip aggregate additive for floor paint, can be added to most floor paints to aid slip resistance.