An economical one coat primer/finish. Quick drying with high sheen level.
Available in 5 Litres . Tintable to most RAL and BS shades.
3. Select a Qty
As low as:
£63.24
Inc VAT£75.89
As low as:
Inc VAT
PRODUCT DETAILS
Centrecoat QD Sheen Primer Finish is an economical one coat primer/finish, with a higher sheen level than usual, for the customer who wants their steel articles to look good without costing the earth.
Best Uses
Centrecoat QD Sheen Primer Finish yields a quick drying high sheen finish to give a good all round durable finish resistant to mild chemicals, with good exterior durability, corrosion resistance, salt spray and excellent re-overcoating properties. Ideal for skips, containers and metal bins.
Available in a wide range of colours including most British Standards, RAL and special colours to customer requirements.
Application
Clean and degrease steel substrate. Rust burrs and oily residues should be removed completely. Sharp edges at welded seams should be ground down. Weld splatter, dust, scale, etc. should be removed. The resultant surface should be dry and free from lamination and dust.
Mix thoroughly before use. Apply a full, even coat. Painting should only be carried out under good atmospheric and clement weather. Painting and preparation should never be undertaken: During fog, mist, snow, or when rain is imminent. When the surface to be painted is wet with condensation or when condensation may occur during the initial drying period.
Excellent re-overcoating properties under normal conditions of temperature and humidity. Can be overcoated with most Xylene based topcoats anytime after through dry (de-nibbing may be required to promote good adhesion).
Yes, Available in a wide range of colours including most British Standard and RAL Shades. Corporate, bespoke and other shades available by arrangement. Some colours contain lead chromate so please state when ordering if lead free pigmentation is required. Please note, bespoke tints are non refundable / exchangeable
VOC Content:
Volume Solids:
42%
Suitable Substrates:
For steel
Application Method:
Airless Spray, Air Assisted Spray or Conventional Spray
Theoretical Coverage:
5m2 per litre at 85 microns
Wet Film Thickness (WFT):
190 - 230 microns
Dry Film Thickness (DFT):
85 microns
Induction Time:
-
Pot Life:
-
Touch Dry:
15 minutes at 20°C
Handle Dry:
2 - 4 hours at 20°C
Fully Cured:
7 days at 20°C
Cleaner / Thinner:
Clean all equipment immediately after use with the above solvent. Ensure all lines, tips, etc. are thoroughly flushed out. It is not sufficient to leave equipment filled up with solvent/thinner. Centrecoat Cladding Protect Thinner
Navigating through the elements of the carousel is possible using the tab key. You can skip the carousel or go straight to carousel navigation using the skip links.
Press to skip carousel
