Rustoleum CombiColor Satin 7300 Aerosols are high performance paints designed for use on all kinds of metal to offer long lasting protection in black or white.
Rustoleum CombiColor 7300 Aerosol is a primer and topcoat all in one and one coat is all that is needed to provide metal substrates with protection that will last a long time. Rustoleum CombiColor 7300 Aerosol is best used for touch ups and application to small areas.
Remove dirt, grease, oil, loose rust and all other surface contaminants by appropriate means. Prime or spot prime with the recommended RUST-OLEUM Primers. Sand intact coatings to provide a proper key for adhesion. The surface must be clean and dry during application. Galvanised, Zinc and Aluminium surfaces have to be primed first with CombiPrimer Tack Coat 3302.
For optimum results the relative humidity shall be below 85% and the temperature of the can and substrate above 10°C. Remove cover cap. Shake vigorously for at least one minute after the rattle of mixing ball is heard. Shake frequently during use. Hold can approx. 25 cm from surface. Use back and forth motion keeping can parallel with surface. Ensure that can is in motion when spray button is pressed to avoid runs and sags. Apply several thin layers at a few minutes interval to achieve adequate coating thickness.After use turn can upside down and press spray button for 2 - 3 seconds to clean valve.
Surface and Environment
Rustoleum CombiColor Satin 7300 Aerosol can be used on all interior and exterior metal surfaces and works especially well on rust, bare metal and wood too. Rustoleum CombiColor 7300 Aerosol Paint offers a quick and easy solution to areas of metal that may have chipped paint or scratches and can cover these damages up in a matter of seconds. Rustoleum CombiColor 7300 Aerosol provides protection against moisture and some resistance to UV light.
|Stock Colours:||7375 Black or 7394 White|
|VOC Content:||535 - 540 g/l|
|Suitable Substrates:||Rust, bare metal|
|Theoretical Coverage:||2 - 3 m² per spray can (400 ml)|
|Wet Film Thickness (WFT):||-|
|Dry Film Thickness (DFT):||-|
|Dry To Handle:||6 hours at 20°C|
|Overcoatable:||After 2 hours at 20°C|
|Fully Cured:||7 days at 20°C|
|Cleaner / Thinner:||-|
|Shelf Life:||5 years from date of production unopened if stored in dry well ventilated areas out of direct sunlight|
|Packaging:||Available as packs of 6 x 400ml aerosols|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.