Rustoleum Hard Hat Anti Rust Primers 2169 2182 are fast drying aerosol primers based on a short oil soya alkyd. These product contain rust inhibitive pigments and are lead and chromate free.
Rustoleum Red Primer 2169 and Grey Primer 2182 are formulated for use on new, bare or slightly rusted steel surfaces. Ideal for use on small areas or as a touch up. Rustoleum Hard Hat Anti Rust Primers 2169 2182 should be used in light industrial exposures, under normal humidity. Interior applications should be recoated with Rust-Oleum Hard Hat Topcoats. Heat resistant to 100°C.
Remove dirt, grease, oil, loose rust and all other surface contaminants by appropriate means. Sand intact coatings to roughen the surface slightly. The surface must be clean and dry during application. Remove cover cap and shake aerosol vigorously for at least 1 minute after the rattle of the ball bearing is heard. Shake frequently during use. Hold can approx 25cm from the substrate. Avoid runs and sags. Apply several thin later at a few minutes intervals. After use turn upside and spray to clean valve.
|Stock Colours:||2182 Grey or 2169 Red Brown|
|VOC Content:||630 g/l|
|Suitable Substrates:||New, bare or slightly rusted steel surfaces|
|Theoretical Coverage:||2.5 m² per spray can at 25 μm dry film thickness.|
|Wet Film Thickness (WFT):||80 μm|
|Dry Film Thickness (DFT):||25 μm|
|Touch Dry:||15 minutes at 20°C|
|Dry to Handle:||30 minutes at 20°C|
|Dry to Recoat:||Within 1 hour or after 48 hours at 20°C|
|Fully Cured:||7 days at 20°C|
|Cleaner / Thinner:||-|
|Shelf Life:||5 years from date of production in unopened cans|
|Packaging:||Available in 6 x 500ml Aerosols|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.