Fosroc Dekguard CP is an environmentally friendly protective coating suitable for application to new and existing concrete structures. It is designed to protect reinforced concrete from chloride ions, oxygen, carbon dioxide (CO2) and other aggressive chemicals.
Dekguard CP is a component of Fosroc’s Renderoc system of concrete reinstatement. Dekguard CP has a wide range of uses, including multi-storey car parks, office buildings, industrial buildings, tunnels and bridges.
Fosroc Dekguard CP is also the recommended primer for Fosroc Dekguard Elastic and Fosroc Dekguard E2000.
Fosroc Dekguard CP is a low viscosity liquid which can be applied by brush, roller or spray.
All surfaces should be dry and free from contamination such as oil, grease, loose particles, decayed matter, moss, algal growth, laitance and all traces of mould release oils and curing compounds. This is best achieved by suitable mechanical means. Where moss, algae or similar growths have occurred, treatment with a proprietary biocide should be carried out.
Prior to application, any surrounding plants, grass, joint sealants, glass windows and PVC frames should be protected. Stir before use. Where Fosroc Dekguard CP is used as a primer for another Dekguard coating, apply one or two coats as required. Where Dekguard CP is used as a self-finish, apply two coats. The first coat should be applied by brush, roller or airless spray equipment.
After the first coat has dried (minimum of 2 hours), apply the 2nd coat (if required). Prior to application by spray, check the prevailing wind direction to avoid overspray onto sensitive surrounding areas.
|Type:||Acrylic copolymer and siloxane|
|Volume Solids:||Approx 17%|
|Application Method:||Brush, Roller or Airless Spray|
|Theoretical Coverage:||4m2 per litre per coat|
|Wet Film Thickness (WFT):|
|Dry Film Thickness (DFT):||Minimum 50 microns|
|Overcoatable:||After 2 - 4 hours at 20°C|
|Cleaner / Thinner:||Dekguard CP should be removed from tools, equipment and mixers with clean water, if necessary with added soap,
immediately after use. Cured material can only be removed mechanically.
12 months if kept in a dry store in the original, unopened packs.
Store in cool, dry conditions, away from sources of heat and naked flames. If stored at high temperatures and/or high humidity conditions the shelf life may be reduced. Must be protected from frost.
|Packaging:||Available in 10 Litres|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.