Hempel Hempadur Speed-Dry ZP 500

Part A and B: UN1263 (Class: 3, Pk Grp: III)
A zinc phosphate 2 pack epoxy paint for use in corrosive environments within a Hempel coatings system.
Available in 20 Litres
From £167.39 £139.49
In stock
Only %1 left
Product Description

Hempel Hempadur ZP 500 is a zinc phosphate 2 pack epoxy paint for use in corrosive environments within a Hempel protective coatings system.

Best Uses

Hempel Hempadur ZP 500 a two-component epoxy paint, which combines high volume solids with a short drying time and optimized properties for shop application of full coating systems. Contains zinc phosphate for better corrosion protection.

Hempel Hempadur ZP 500 is suitable for onshore corrosion protection of new-build steel constructions where fast to handle and short overcoating times are required, such as steel for factory buildings, stadiums, exhibition halls, airports, power plants, refineries, chemical and petrochemical plants.


Steel work: The steel surface shall be thoroughly prepared so that the coating achieves an even distribution at the specified nominal dry film thickness.

New steel: Abrasive blasting to Sa 2½ (ISO 8501-1:2007). For temporary protection, if required, use a suitable shop primer. All damage of shop primer and contamination from storage and fabrication should
be thoroughly cleaned prior to final painting. For repair and touch-up use: Hempel Hempadur ZP 500.

Maintenance: Remove oil and grease etc. thoroughly with suitable detergent. Remove salts and other contaminants by high pressure fresh water cleaning. Remove all rust and loose material by wet or dry abrasive blasting or power tool cleaning. Feather edges to sound and intact areas. Dust off residues. Touch up to full film thickness. After wet abrasive blasting hose down the surface with fresh water and allow drying.

Technical Details
Components: Two Pack
Type: Epoxy
Finish: Flat
Stock Colours: 50630 Red, 17330 Grey
Tintable: No
VOC Content: 235 g/L
Volume Solids: 75%
Suitable Substrates: Steel
Application Method: Spray, Brush
Theoretical Coverage: 6 m2 per litre at 125 micron / 5mm
Wet Film Thickness (WFT): 100 - 200 microns
Dry Film Thickness (DFT): 70 - 150 microns
Induction Time: -
Pot Life: 1 hour 30 minutes at 20°C
Surface Dry: Approx 1 hour at 20°C
Overcoatable: See data sheet
Fully Cured: 7 days at 20°C
Cleaner / Thinner: Hempel's Tool Cleaner 99610
Shelf Life: 3 years for base and 1 year (25°C) for curing agent from time of production.
Packaging: Available in 20 Litres

The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.

Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.

Related Products