Hempel Hempadur Speed Dry ZP 600

SKU
id22966
Part A: UN1263 (Class:3, Pkg Grp: III), Part B: UN3469 (Class: 3.8, Pkg Grp: III)
A self-priming, two-component, high build epoxy paint containing zinc phosphate.
Available in 5 and 20 Litres
From £39.85 £33.21
In stock
Only %1 left
Product Description

Hempel Hempadur Speed Dry ZP 600 is a self-priming, two-component, high build epoxy paint containing zinc phosphate. Suitable for corrosive environments.

Best Uses

Hempel Hempadur Speed Dry ZP 600 is formulated as a fast curing primer or intermediate coat in mild to severely corrosive environment. Hempel Hempadur Speed Dry ZP 600 is also suitable a topcoat where the usual cosmetic performance of epoxy coatings is acceptable or as a single coat direct to metal in mild corrosive environment.

Application

Preparation For New Steel: Remove oil and grease etc. thoroughly with suitable detergent. Remove salts and other contaminants by high pressure fresh water cleaning. Abrasive blasting to minimum Sa 2 (ISO 8501-1:1988) with a surface profile corresponding to Rugotest No. 3 BN 10, Keane-Tator Comparator 3.0 G/S or ISO Comparator, rough Medium (G). After blasting, clean the surface carefully from abrasives and dust.

For Repair and Maintenance: Remove oil and grease, etc. with suitable detergent. Remove salt and other contaminants by high pressure fresh water cleaning. Remove all rust and loose material by wet or dry abrasive blasting or power tool cleaning. Feather edges to sound and intact areas. After wet abrasive blasting hose down the surface with fresh water and allow drying.

Please note. epoxy coatings have a natural tendency to chalk and change colour in outdoor exposure. This does not affect the performance of these coatings.

Technical Details
Components: Two Pack
Type: Zinc Phosphate Epoxy
Finish: Flat
Stock Colours: 50630 Red in 20 Litres, and Grey and White in 5 Litres.
Tintable: No
VOC Content: 280 g/L
Volume Solids: 41%
Suitable Substrates: For steel
Application Method: Airless Spray or Brush
Theoretical Coverage: 7.1 m2 per litre at 100 microns
Wet Film Thickness (WFT): 150 microns
Dry Film Thickness (DFT): 100 microns
Induction Time: -
Pot Life: 1.5 hours at 20°C
Touch Dry: 2 hours at 20°C
Overcoatable: See data sheet
Fully Cured: 7 days at 20°C
Cleaner / Thinner: Hempel Tool Cleaner 99610
Shelf Life: See container
Packaging: Available in 5 and 20 Litres

The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.

Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.

Recommended products to use