Hempel Hemucryl Enamel Hi-Build 58030 is a water-borne, acrylic dispersion based paint for interior and exterior moderate to severe corrosive environments.
Hempel Hemucryl Enamel Hi-Build 58030 dries to a non-yellowing and glossy coating with low dirt pick-up, good weathering properties, and high gloss retention. Especially suited for application by airless spray. Hempel Hemucryl Enamel Hi-Build 58030 is formulated as a glossy, finishing coat in water-borne paint systems, interior and exterior, in moderately to severe corrosive environments.
Hempel Hemucryl Enamel Hi-Build 58030 is for use on buildings the relatively high resistance to diffusion of water vapour and carbon dioxide should be taken into account. For handrails and the similar, a chemically curing coating is alternatively recommended.
Preparation For New Steel: Remove oil and grease etc. thoroughly with suitable detergent. Remove salts and other contaminants by high pressure fresh water cleaning. Abrasive blasting to the cleaning degree specified for the final coating system, usually Sa 2½ (ISO 8501-1:2007). Prime with: HEMUCRYL PRIMER
Preparation For Repair and Maintenance: Remove oil and grease etc. thoroughly with suitable detergent. Remove salts and other contaminants by high pressure fresh water cleaning. Remove rust and loose paint by abrasive blasting or power tool cleaning to St 3 (ISO 8501-1:2007) (minor areas) before recoating. Dust
off residues. Prime with: HEMUCRYL PRIMER Touch up bare spots with: HEMUCRYL ENAMEL HI-BUILD 58030. Otherwise according to specification.
If application is done by roller/brush, apply liberally. Use brushes with synthetic fibres. Rollers should either be mohair or felt.
|Stock Colours:||10000 White|
|Tintable:||Yes, to most RAL or British Standard codes. Please note, bespoke tints are non refundable / exchangeable|
|VOC Content:||52 g/L|
|Suitable Substrates:||For use in a water borne Hempel paint system|
|Application Method:||Airless Spray / Brush|
|Theoretical Coverage:||5.9 m2 per litre at 75 microns|
|Wet Film Thickness (WFT):||175 microns|
|Dry Film Thickness (DFT):||75 microns|
|Surface Dry:||20 minutes at 20°C|
|Overcoatable:||Dependant on Specification|
|Thorugh Dry:||1 hour at 20°C|
|Cleaner / Thinner:||Water|
|Shelf Life:||See packaging|
|Packaging:||Available in 5 and 20 Litres|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.